EDIFIER MP700 Portable Speaker User Manual
- June 17, 2024
- Edifier
Table of Contents
MP7OO
Portable Speaker
Haut-parleur Portable
Important safety instruction
WARNING: To reduce the r sk of fire or electric shock, do not expose this apparatus to ra n or moisture.
- Keep these instructons.
- Follow all nstructions.
- Do notusethisapparatusnearwater
- Clean on y with dry cloth.
- Do not nstall near any heat sources such as radiators, heat registers, stoves, or other apparatus (includ ngamplifiers)thatproduceheat.
- Only use attachments/accessories specified by the manufacturer.
- Refer all servicing to qua ified service personnel. Servicing s required when the apparatus has been damaged n any way, such as power-supply cord or plug is damaged, liquid has been sp lledorobjectshavefallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
- The maximum ambient temperature is 35 C.
Note:
There is a built-in rechargeable lithium-ion battery in the speaker.
Danger of explosion f the speaker is disassembled. The speaker must not be
placed close to excessive heat such as fire or the like.
Correct Disposal of this product. This marking indicates that this product
should not be disposed with other household wastes throughout the EU. To
prevent possible harm to the environment or human health from uncontrolled
waste disposal. recycle to responsibly to promote the sustainable reuse of
material resources. To return your used device. please use the return and
collection systems or contact the retailer where the product was purchased.
They can take this product for environmental safe recycling.
Unpack the box
Box content
Charging the Battery
- Before first use charge the speaker fully, with the power off, for approximately 2.5 hours. When charging, the LED power indicator strip will blink & travel up the indicator until fully charged. When charging s complete, the indicator lights will all go off.
- Each time the speaker s turned on, audio source is selected, the power evel indicator strip will blink once to display current power level.
- For best speaker performance, please check the battery power level before each use.
Operation
-
LED indicator
Red: Aux
Blue: Bluetooth -
ON /standby/Audio source selector
ON: press once
Standby: press and hold
Audio source selector: press once (ON) -
Volume down I Previous track
Previous track: press and hold (Bluetooth mode)
Volume down: press once -
Volume up I Next track
Next track: press and hold (Bluetooth mode)
Volume up: press once -
NFC (Near Field Communication) receiver
-
Line in input
-
DC output
-
DC input
-
Charging/battery power ndicator
Connections
Bluetooth Connection
- Turn on the speaker
- On your device (mobile phone, tablet device, MP3/MP4 player etc.), go to Bluetooth to search and select “EDIFIER MP700”.
- Pair your device with “EDIFIER MP700”.
- When Bluetooth is not connected, the blue LED blinks.
- Touch play on your device and adjust the volume to a desired level.
- Play/pause: press the volume +/- button at the same time
Note:
- Bluetooth connectivity and compatibility may be different between different source devices, depending on the software version of the source.
- To enjoy the full Bluetooth functions of this product, please ensure your mobile device has A2DP profile.
- PIN code for connection is “O000” if needed.
NFC (Near Field Communication) function
- Turn on the speaker
- Switch on the NFC function on your device
- Put your device near the speaker. The Bluetooth connection will be made automatically by NFC. Your device is now connected to the speaker.
- Play the music on your device and adjust the volume to a desired level.
Disconnection: You can switch off NFC function after the Bluetooth
successfully connected, and the speaker will remain Bluetooth connection.
Audio Cable Connection
Connect to source using 3.5mm auxiliary cable included.
Note:
When the speaker s n Bluetooth mode, you need to press Into AUX mode and the
LED ndicator turn to red.
Spare power source output
The USB output can be used to charge your mobile device up to 5V maximum 500mA DC using a USB cable. USB cable not included.
Specification
Power output::| RMS 10Wx2 (mid-range and bass)
+8Wx2 (treble)
---|---
Signal to noise ratio:| 85dBA
Frequency response:| 80Hz-20KHz (±3dB)
Input sensit vity:| 800 ± 50mV
Input type:| Bluetooth /Auxiliary
Mid-range unit:| 2%'” (70mm)
Treble unit:| 19mm silk dome tweeter
Troubleshooting
- Switch the EDIFIER MP700 off then on and reconnect to the audio source.
- Ensure Bluetooth function is enabled on your Bluetooth devices.
- Move the devices closer and retry the connection.
- Try another Bluetooth device for connection.
- Check the power cord connection and make sure the wall outlet is on.
- Switch the system off then on and reconnect to the audio source.
- Confirm that the system is ON and not in STBY mode.
- Check the master volume and confirm that it is turned up.
- Check for proper connections of the audio input cable.
- Check audio source to confirm that it is functioning properly.
Thank you for purchasing this EDIFIER product. For warranty information
regarding your new purchase please visit
www.edifier.com
If you have any further questions or concerns regarding EDIFIER Products
anywhere in the world. please visit our website at:
www.edifier.com, or email EDIFIER Support for
further assistance at: main@edifier.com.
To contact us by phone: 1-877-EDIFIER (334-3437) in US and Canada; for South
America: Please visit www.edifier.com (English) or
www.edifierla.com (Spanish/Portuguese) for
detailed local contact information. “© 2013 CSR plc and its group companies.
The aptX® mark and the aptX logo are trade marks of CSR plc or one of its
group companies and may be registered in one or more jurisdictions.”
are registered trademarks owned by Bluetooth SIG, Inc.
NFC Forum and the NFC Forum logo are trademarks of the Near Field
Communication Forum.
NOTICE:
For the need of technical mprovement and system upgrade.information contained
herein may be subject to change from time to t me without prior notce.
Products of EDIFIER w ll be customized for different applications. Pictures
and illustrations shown on th s manual may be slightly different from actual
product. f any difference is found, the actual product prevails.
Manual Edition 1.1, Aug. 2015
B-200-M07000-03
8038079
mported by Imcorte par
The SourceSource
Barrie, Ontario, Canada, L4M 4W5
Manufactured in China
www.thesource.ca
www.lasource.ca
Edifier International Ltd.,
Suite 1610
16th Floor, Tower II,
Lippo Centre,
89 Oueensway
Hong Kong
Tel: +852 2522 6989
Fax: +852 2522 1989
www.edifer-international.com
© 2015 Edifier International Limited. All rights reserved.
Printed in China
https://manual-hub.com/