ESR 6C004 Pro Digital Pencil User Manual
- June 17, 2024
- ESR
Table of Contents
ESR 6C004 Pro Digital Pencil User Manual
Using Your Pencil
Turning On: Attach Pencil to iPad magnetic connector OR long press button for 2 seconds. Charging: Charge via USB-C port OR attach Pencil to iPad magnetic connector.
Standby Mode: After 5 minutes of inactivity, Pencil enters standby mode. For 25 minutes after entering standby mode, Pencil wakes automatically when used.
Status Light Guide
On : Blue light.
Low Battery (Below 10%): Red light flashes.
Charging: Red light pulses. When fully charged, light changes to green and is on for 30 seconds then turns off. Status Light Guide
Pairing Mode : Long press button for 2 seconds to enter pairing mode then go to Settings >
Bluetooth > Device List and select “ESR Digital Pencil Pro”. (Pencil can be used without being paired, but shortcuts and on-screen power level will be unavailable.)
Button Shortcuts: Press button once to go to iPad Home Page, double press to go to iPad Multitasking view.
FAQ
Q: What should I do if the Pencil isn’t working?
A: 1. Before using Pencil, magnetically attach to iPad magnetic connector. 2. If status light flashes red, battery level is below 10% and Pencil needs to be charged. 3. If battery is sufficient, Pencil may be in standby mode. To wake Pencil, use it with your iPad.
FCC ID：2APEW- 6C004
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
IC：24790- 6C004
This device complies with Industry Canada licence-exempt RSS standard( s). Operation is subject to the following two conditions:
- this device may not cause interference, and
- this device must accept any interference, including interference that may cause undesired operation of the device.”
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without
Declaration of Conformity
This product is intended for use within Europe. Electronic Silk Road Corp. hereby declares that this product 6C004 is in compliance with the essential requirements and other relevant provisions of Directive 2014 /53/EU,2014 /35/EU,2014 /30/EU. The Declaration of Conformity for the 6C004 is available from www.esrgear.com
Product name: ESR Digital Pencil Pro
Model: 6C004
Input: 5V⎓500mA
Brand: ESR
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>