Ford Performance Parts GT350 Mustang Oil Separator Instruction Manual
- June 17, 2024
- Ford Performance Parts
Table of Contents
Ford Performance Parts GT350 Mustang Oil Separator
Please visit www.fordracingparts.com for the most current instruction and warranty information.
PLEASE READ ALL OF THE FOLLOWING INSTRUCTIONS CAREFULLY PRIOR TO INSTALLATION. AT ANY TIME YOU DO NOT UNDERSTAND THE INSTRUCTIONS, PLEASE CALL THE FORD PERFORMANCE TECHLINE AT 1-800-367-3788
Kit contents
- 1 – Oil separator
- 2 – Hoses
- 1 – Push pin 6mm
- 1 – Push pin 8mm
- 1 – Nut, flanged self locking
Installation Instructions
-
Step 1. Remove breather tube marked #1 from air inlet tube and valve cover.
NOTE: Non R models require minor trimming of sound deadening material to access mounting location for 6mm push pin. (see arrow) -
Step 2. Install oil separator using the 2 pushpins and 1 nut. Larger 8mm push pin in used in the location under strut brace. Lightly tighten nut so not to deform separator bracket.
-
Step 3. Install the 2 breather hoses.
The picture below shows the RH M-6766-A50 and the LH M-6766-A50S installed on a GT350 Mustang.
Maintenance is based on the type of driving the vehicle is subjected to.
Track type driving will require more frequent checks for accumulation of oil
in the separator.
Remove separator and tilt so to empty oil out from the lower fitting. Do not
empty from upper fitting!
If removal of the top cover is required, when reinstalling torque socket head
screws to 4.5 to 5 Nm.
Factory Ford shop manuals are available from Helm Publications, 1-800-782-4356
Techline 1-800-367-3788
References
- Official Site of Ford Performance Parts - Mustang Parts, Crate Engines, Packs, Wheels, Superchargers, Racing Parts | Performance Parts Authority
- Manual-Hub.com – Free PDF manuals!
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>