Ford Racing Performance Parts M-6014-BOSS Cylinder Head Stud Kit Instruction Manual
- June 17, 2024
- Ford Racing Performance Parts
Table of Contents
Ford Racing Performance Parts M-6014-BOSS Cylinder Head Stud Kit
Instruction Manual
BOM
Description | Quantity |
---|---|
4.060 OAL stud | 10 |
5.750 OAL stud | 10 |
Hardened washer | 20 |
12pt. ½ – 20 nut | 20 |
INSTALLATION INSTRUCTIONS
Before installing cylinder heads for final assembly:
STEP 1: Loosely assemble and check for interference between the exterior
head studs and exhaust header(s).
STEP 2: Install studs into block and torque to 3-5 lb ft.
STEP 3: Install head gasket.
STEP 4: Install cylinder heads.
STEP 5: Install washers (10 per side).
STEP 6: Lubricate ½”-20 thread with engine oil (lightly).
STEP 7: Install nuts (10 per side).
STEP 8: Torque in 3 steps:
- Tighten all nuts in sequence to 35 lb ft +/- 5.
- Tighten all nuts in sequence to 65 lb ft +/- 5.
- Tighten all nuts in sequence to 100 lb ft +/- 5.
NO PART OF THIS DOCUMENT MAY BE REPRODUCED WITHOUT PRIOR AGREEMENT AND WRITTEN PERMISSION OF FORD RACING PERFORMANCE PARTS.
Please visit www.fordracingparts.com for the most current instruction information
! ! ! PLEASE READ ALL OF THE FOLLOWING INSTRUCTIONS CAREFULLY PRIOR TO
INSTALLATION.
AT ANY TIME YOU DO NOT UNDERSTAND THE INSTRUCTIONS, PLEASE CALL THE FORD
RACING TECHLINE AT 1-800-367-3788 ! ! !
References
- Official Site of Ford Performance Parts - Mustang Parts, Crate Engines, Packs, Wheels, Superchargers, Racing Parts | Performance Parts Authority
- Manual-Hub.com – Free PDF manuals!
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>