kogan KAPURIOHEPA Ionic Home Air Purifier Tower User Manual

: June 17, 2024
: Kogan

Table of Contents

IMPORTANT SAFEGUARDS
MAIN PARTS
OPERATION
CLEANING AND MAINTENANCE
TROUBLE SHOOTING TIPS
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Ionic Home Air Purifier Tower
KAPURIOHEPA
USER MANUAL

IMPORTANT SAFEGUARDS

READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE.
WARNING: RISK OF ELECTRICAL SHOCK

Safety precautions should always be used when operating this or any electrical appliance.
Decrease the risk of electrocution, electric shock, injury or fire by reading and following all of the warnings below.
To reduce the risk of electric shock, do not attempt to service the air purifier in any way other than to replace or clean the air filter.
Read all instructions before operating the air purifier.
This product operates at 220-240V, 50/ 60Hz.
Do not run the power cord under carpets, and do not cover with throw rugs, blankets or towels.
This product is not intended to filter oil or grease from air.
Always unplug the power cord from the electrical outlet when the air purifier is not in use or when changing the filter.
Never run the air purifier unless it is fully assembled.
Do not alter the plug in any way.
Always turn off the air purifier before unplugging the air purifier from outlet.
Do not place the cord near a heated surface.
Never operate the air purifier if the plug or cord is damaged or appears damaged. Only qualified service personnel should ever replace or attempt to replace a damaged power cord.
Never use the power cord to pick up, carry, drag, pull, or lift the air purifier. Do not pull the cord against or around sharp corners and edges.
Always remove the plug from its power outlet by holding onto the plug itself and pulling gently.
Never pull on the cord itself to unplug it from its power outlet.
Use care when operating the air purifier by keeping all foreign objects, fingers, body parts, hair, loose clothing and jewelry away from openings.
Never touch the air purifier or its plug when your hands are wet.

Note:
Before operating the air purifier, make sure the air filters inside the air purifier are not wrapped in plastic. When the air purifier is plugged in you should hear a beep. Press the Power button to turn it on. If the air purifier does not power on, ensure the front cover is installed correctly.

Save these instructions!

MAIN PARTS

OPERATION

PRE-OPERATING INSTRUCTIONS

Carefully remove your air purifier from the gift box and the bag.
Remove the back cover and remove the filter from the bag.
Select a firm, level and flat location. For proper air flow, locate the unit at least 1 foot (0.3 M) from any wall or furniture. Ensure no grilles are blocked.
Plug the power cord into a 220-240V AC outlet.

OPERATING INSTRUCTIONS

The air purifier is operated by the manual controls located on the top of air purifier (as shown in Unit Top View).

Plug the air purifier into a 220-240V AC outlet
Turn the air purifier on by pressing On/Off Button ( ).
Upon turning the air purifier on, the power indicator will be lit, the unit will be in the High fan speed ( ), and the ionizer will start to work.
Pressing Fan Speed Button ( ) at this point will set the air purif ier into Medium fan speed ( ).
Pressing Fan Speed Button ( ) again will set the air purifier into Low fan speed ( 1 ).
Pressing Fan Speed Button ( ) once more will set the air purifier back to High fan speed ( ).
To turn the air purif ier off, press the On/Off Button ( ).

NEGATIVE ION FUNCTION
To turn the air purifier on, press the On/Off Button ( ),the ionizer also works,during the air purifier working time,the ionizer is always working.

UV LAMP FUNCTION
The UV-C germicidal lamp can kill harmful airborne bacteria and virus. This function will work in any mode. Press the UV Button ( ) to start the UV lamp and stop the UV lamp by pressing the UV Button ( ) again.

UV LAMP RESET FUNCTION:
If the UV lamp needs to be replaced, the UV icon on the LCD will illuminate and flicker. After replacing the UV lamp, reset the UV lamp by pressing the UV Button ( ) for a few seconds, the UV icon will stop flickering and the new UV lamp will start to work. Check from the UV view window (Unit Front View in page 2), if the UV lamp still lights, it should not be replaced.

HEPA RESET FUNCTION:
If the HEPA filter needs to be cleaned, HEPA Reset icon on LCD will illuminate and flicker. After cleaning the HEPA filter, RESET the HEPA filter by using a pin or needle to press the HEPA RESET Button ( ), then the icon will stop flickering. For instructions on how to clean the HEPA filter see the CLEANING HEPA FILTER on page 6.

CLEANING AND MAINTENANCE

CLEANING PRE-FILTER (See Air Cleaning System)

Turn off and unplug the unit;
Press the Lock & Release Button and remove the Rear Cover from the unit; NOTE : The unit will shut off after the rear cover is removed.
Remove the pre-f ilter from the rear cover. Clean the pre-filter with the vacuum brush attachment of your vacuum cleaner. This will remove lint and dirt from the filter. Use a clean, damp, soft cloth to wipe the pre-f ilter again. NOTE: Clean the pre-f ilter often if possible.
After cleaning, reattach the pre-f ilter to the rear cover, and install the rear cover back to unit and securely latch in place.

CLEANING HEPA FILTER (See Air Cleaning System)

Turn off and unplug the unit;
Press the Lock & Release Button and remove the Rear Cover from the unit; NOTE: The unit will shut off after the rear cover is removed.
Remove the HEPA filter.
Use the brush attachment with your vacuum cleaner to clean the filter. CAUTION: Do not use water or any household cleaner to clean the HEPA filer.
NOTE: The HEPA filter can be used continuously for up to two years. When the HEPA filter turns from white to black, it should be replaced with a new one. If the HEPA filter is still white, it does NOT need to be replaced.
Depending upon your f ilter type, either it will only f it in one way or reference the arrow on the side of the f ilter. Install the rear cover back to unit and securely latch in place. NOTE: Both of f ilter and rear cover must be installed otherwise the purifier will not power on.

REMOVING/INSTALLING UV LAMP (See Air Cleaning System)

Turn off and unplug the unit.
Press the Lock & Release Button and remove the Rear Cover from the unit. NOTE: The unit will shut off after the rear cover is removed.
Remove the HEPA filter.
Use a screwdriver to remove the two screws and detach the UV lamp cover.
Grasp the UV lamp and pull it straight out from the lamp socket. The lamp is made of quartz so it is stronger than a standard UV lamp, however we recommend reaching in toward the base since it is easier to remove from here than pulling on the end of the lamp. If you have rubber gloves or something similar that has a non-slip grip that is preferable. You should minimize the contact time with your fingers on the glass. CAUTION: The UV lamp is a glass product, please handle it carefully. Please reference www.kogan.com for more information in regards to the safest way to replace the UV lamp.
Take a new UV lamp and insert it into the lamp socket. Simply press in on the end of the glass lamp to lock into place. Re-install the UV lamp cover (the large metal face should be above the uv lamp and align the two screw holes with the back of the air purifier), then re-install the f ilter and rear cover.

CLEANING AND MAINTENANCE

The air purif ier should be checked at least once every month. More frequent cleaning may be required depending upon environmental conditions.
Clean the HEPA f ilter and pre-filter with the vacuum brush attachment of your vacuum cleaner. This will remove lint and dirt. See CLEANING PRE-FILTER and CLEANING HEPA FILTER on page 5 to 6.
Check the UV lamp from the UV view window (Unit Front View in page 2). If the UV lamp needs to be replaced, see REMOVING/INSTALLING UV LAMP on page 8.
Use a clean, dry, soft cloth to wipe the external surface of unit.

NOTE: Do not stick any foreign objects or your fingers inside the unit.
CAUTION: Do not use any chemical or harsh cleaners, etc., as they will damage the product. NEVER use ALCOHOL OR SOLVENTS.

TROUBLE SHOOTING TIPS

If the air purif ier shuts off unexpectedly, safety features may have been activated to prevent damage or injury. If this happens:

Be sure the air purifier is plugged into a working electrical outlet;
Check to be sure the UV lamp and UV lamp cover are f irmly seated in place;
Check to be sure the HEPA f ilter is firmly seated in place;
Check to be sure the rear cover is latched f irmly in place.

NOTE: IF YOU CONTINUE TO EXPERIENCE A PROBLEM, PLEASE CONTACT THE THE KOGAN CUSTOMER SUPPORT TEAM IN REGARDS TO THE WARRANTY. DO NOT ATTEMPT TO TAKE APART THE UNIT BY YOURSELF. DOING SO MAY VOID YOUR WARRANTY AND CAUSE DAMAGE TO THE PRODUCT OR PERSONAL INJURY.