kogan KADVR1CGPS Full HD Car Dash Camera with GPS User Guide
- June 17, 2024
- Kogan
Table of Contents
- kogan KADVR1CGPS Full HD Car Dash Camera with GPS
- Product Information
- Product Usage Instructions
- Product Features
- Product Layout
- Usage
- Operation
- Video and Photo File Playback
- System Setup Options
- Connecting to Computer
- Technical Specifications
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
kogan KADVR1CGPS Full HD Car Dash Camera with GPS
Product Information
Specifications
- Product Name: Kogan Full HD Car Dash Camera with GPS
- Battery Capacity: 180mAh
- Battery Charging Time: Approximately 180 minutes
- Memory Card Compatibility: High-speed Micro SD card of Class 4 or higher, up to 32GB
Product Layout
- Camera lens
- HDMI interface
- USB/AV OUT interface
- GPS
- Display screen
- Signal receiving window
- Menu key
- Down key
- OK key
- Emergency recording key
- Mode key
- Power key
- Up key
- Light indicator
- Video recorder hole
- Micro SD card slot
- Reset keyhole
- DC slot
- Horn hole
Product Usage Instructions
Starting use
Note: The recorder will power off automatically after the low-power alarm
while no external power source is connected.
Language setup
After starting up, press the MENU key, enter the main menu and press UP/DOWN
to select language setup. Press the OK key to enter into the language setup.
Press UP/DOWN until you have highlighted your preferred language, then press
OK.
Battery charging
There are three ways to charge the battery:
- Charge via USB cable
- Charge via vehicle power
- Charge via USB cable plugged into a USB wall adaptor (not included)
During charging, the red indicator light will be on and charging should take approximately 180 minutes. Once charging is complete, the red charging indicator will go out if you are using your car power or a USB cable with an adaptor.
Inserting memory card
Push the micro SD card into the card slot in the direction indicated by the
markings on the camera body. When the card is fully inserted and clicks into
place, stop pushing. Note: this unit requires a high-speed Micro SD card of
Class 4 or higher, up to 32GB in size.
Removing memory card
Push the micro SD card slightly in further to the unit, at which point it will
partially pop back out of the camera.
Operation
Switch between video/photo/playback
Press the mode key to switch between video/photo/video file playback/picture
file playback.
Taking videos and setting video options
Taking videos: Once the recorder is turned on, press the OK key to start
recording. Press the OK key again to stop recording. Video setup options:
Press the MENU key to enter into the main menu, then select image parameters
and press OK to enter. The options are as follows.
- Movie mode: FHD/30fps, HD/30fps, HD/60fps, VGA/30fps
- Movie quality: Super high quality, High quality
- Movie clip time: 1 minute, 3 minutes, 5 minutes, 10 minutes, close
- Movie off time: 0 minute, 5 seconds, 30 seconds, 1 minute, 2 minutes, 3 minutes
- Sound record: On/Off
- MIC sensitivity: Low/Medium/High
- Scene: Normal/Event/Parking
FAQ
-
Q: How long does it take to charge the battery?
A: Charging should take approximately 180 minutes. -
Q: What type of memory card is compatible with this dash camera?
A: This dash camera requires a high-speed Micro SD card of Class 4 or higher, up to 32GB in size. -
Q: How do I switch between video, photo, and playback modes?
A: Press the mode key to switch between video/photo/video file playback/picture file playback. -
Q: How do I start and stop recording videos?
A: Once the recorder is turned on, press the OK key to start recording. Press the OK key again to stop recording.
Thank you for purchasing the Kogan Full HD Car Dash Camera with GPS. To ensure
that you get the most out of the unit, please read the user manual before use.
Please charge the unit for 8 hours prior to the first use to ensure that the
180mAh battery operates at its full capacity.
Product Features
- Ultra small, 120 degree, high resolution and ultra wide-angle lens.
- Built in microphone/speaker.
- Cyclic recording function automatically deletes old files and makes room to record new files.
- When left plugged into charger, will automatically turn on and start recording when the engine starts up.
Product Layout
- Camera lens
- HDMI interface
- USB/AV OUT interface
- GPS
- Display screen
- Signal receiving window
- Menu key
- Down key
- OK key
- Emergency recording key
- Mode key
- Power key
- Up key
- Video recorder hole
- Light indicator
- Micro SD card slot
- Reset key hole
- DC slot
- Horn hole
Usage
Starting use
- Start up: press the power button for 3 seconds. The green indicator light will light up.
- Power off: press the power button for 3 seconds again. Press the OK button, then select “YES” to the confirmation question and the green indicator light will go out.
Note: the recorder will power off automatically after the low-power alarm while no external power source is connected.
Language setup
After starting up, press the MENU key, enter the main menu and press UP/DOWN
to select “ ” language setup. Press the OK key to enter into the language
setup. Press UP/DOWN until you have highlighted your preferred language, then
press OK.
Battery charging
There are three ways to charge the battery.
- Charge via USB cable
- Charge via vehicle power
- Charge via USB cable plugged into a USB wall adaptor (not included)
During charging, the red indicator light will be on and charging should take approximately 180 minutes. Once charging is complete, the red charging indicator will go out if you are using your car power or a USB cable with an adaptor.
Inserting memory card
Push the micro SD card into the card slot in the direction indicated by the
markings on the camera body. When the card is fully inserted and clicks into\
place, stop pushing.
Note: this unit requires a high speed Micro SD card of Class 4 or higher,
up to 32GB in size.
Removing memory card
Push the micro SD card slightly in further to the unit, at which point it will
partially pop back out of the camera.
Operation
Switch between video/photo/playback
Press the mode key to switch between video/photo/video file playback/picture
file playback.
Taking videos and setting video options
-
Taking videos
Once the recorder is turned on, press the OK key to start recording. Press the OK key again to stop recording. -
Video setup options
Press the MENU key to enter into the main menu, then select “ ” image parameters and press OK to enter. The options are as follows.
-
Taking Photos
Press the mode button to capture mode. Press OK to take photos. -
Image Setup Options
Press the MENU key to enter the main menu, then select image shooting and press OK to enter the settings.
File Management
Press the mode key to enter video playback mode or picture playback mode to
manage your files.
Video and Photo File Playback
-
Video Playback
Press Mode Key to select playback mode. The first playback mode is video mode, with the format showing AVI on top. Press UP/DOWN to select the video or audio files to be played back. Press OK to start or stop playing the video and audio files, and press UP/DOWN to fast-forward or rewind, then press OK to resume normal speed. Press the Mode Key to return to the square up image. -
Photo Playback
Press the mode key to enter into the photo playback mode, with the format showing JPG on top. Press OK to enter into single photo playback mode. In single photo playback mode, press UP/DOWN to select the photos to be played back. Press the Mode Key to return to square up mode. -
Delete, Protect and Volume
In playback mode, press the Menu Key to show “ ” up volume, “ ” delete and “ ” protection options. Select volume and press the OK key to set volume. Press UP/DOWN to choose a volume level from 0 to 10, then press OK to confirm. Press the DOWN key to move to deletion options, then press OK to move into either “ remove a single file” or “ delete all” options. Press the OK key to choose which file you wish to delete. To protect files, press the DOWN key to the protection options, then press OK to enter into either “ Protect single file”, “ Unlock single file protection”, “ Protect all files” or “ Unlock all files” options, then press OK to confirm.
System Setup Options
Press the MENU key under VIDEO or PHOTO SHOOTING mode, then press the DOWN key, entering into “General Settings”, then “system setup” icon. Press the OK key to enter into setup options.
Connecting to Computer
Video and photo download
-
When the camera is connected to your computer via USB, the red power indicator should come on. Then computer will automatically identify the camera as a removable disk (assuming the micro SD card is inserted).
Note: Computer operating systems must be Windows 2000 or newer, or MAC OS x 10.3.6 or higher. -
Use a computer to browse and manage files.
-
Remove the USB cable to close the data recorder.
Note: if the unit crashes while using it and is not resuming use, press the reset button. The equipment will then return to normal operations.
Technical Specifications
| LCD screen dimensions | 2.0LTPS (4:3) |
|---|---|
| Lens | 120 degree, A+ level, high resolution, ultra-wide angle lens. |
| Language options | English/Portuguese/Traditional Chinese/Simple |
Chinese/Russian/Spanish
Video| FHD 30fps/HD 60fps/HD 30fps/VGA 30fps
Video format| AVI
Picture resolution| 14M/12M/8M/5M/3M/2M/1.2M/VGA
Memory card slot| Micro SD (up to 32GB)
Microphone/speaker| Built in
Power supply frequency| 50/60Hz
Television output| PAL/NTSC
USB interface| USB2.0
Power interface| 5V 1000MA
Battery| Built-in lithium battery, 310mAH
System requirements| Windows 2000/XP/Vista/7/8/8.1 MAC OS x 10.3.6 or higher
If you have any further questions regarding use of this product, please contact the Kogan customer support team.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>