AQUADISTRI BlueMarine Internal Skimmer 200 Instruction Manual
- June 4, 2024
- AQUADISTRI
Table of Contents
AQUADISTRI BlueMarine Internal Skimmer 200
Instruction Manual
- Air Flow adjusting valve
- Collection cup lid
- Collection cup
- Seal
- Air hose
- Water level adjusting knob
- Bottom plate
- Nylon botom plate screws 4x
- Mounting screw
- Air venturi
- Pump
- Holding bracket
- Holding bracket mounting screw
- Waste valve
- Controller
Safety
- Read carefully before usage.
- The Internal Skimmer 200 is only suitable for indoor use.
- Ensure voltage shown on the label match to the mains supply voltage.
- Ensure that water cannot reach the socket.
- Never let the pump run dry, keep it submerged at all times.
- Disconnect skimmer from mains before any maintenance on your aquarium.
- If the cables of pump or controller is damaged, do not use the skimmer, recycle the damaged item and order a new pump or controller at your dealer.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Special care should be taken with the use of electrical equipment by or near children.
Installation Internal skimmer 200
- Connect the air venturi (10) to the Air Flow adjusting valve (1) by using the supplied air hose (5).
- Now connect the skimmer ballast to the power outlet.
- Adjust the pump power by using the controller (16) and adjust the water level with the adjusting knob (6).
- Be careful using the skimmer just after you have filled your tank with freshly mixed salt as this can cause extreme foaming and overflow.
- The controller has to be in a dry place, the controller is not water proof (damage due to water damage is no warranty!)
Maintenance
- To operate efficiently, the Blue Marine skimmer must be 24 hours a day in use
- Check daily if your skimmer is functioning properly and produces the desired foam
- Check daily if the collection cup is full and clean it completely when needed.
- Check and clean pump regularly to ensure it does not become clogged, dirty pumps may break down, not maintained pumps are not covered by warranty.
- For easy maintenance you can connect the waste hose with valve (15) to the collection cup for external collection into a bucket.
Operation
Change the running speed of the pump, to adjust the flow by turning the knob
(a) to the right or left.
Recycle information
The symbol of the barred bin printed on the product means that it must be
collected separately from other rubbish when it will not be anymore in use.
The user, at the end of the life of the product, will have to bring it to a
proper rubbish collection centre for electric and electrical devices.
Alternatively he can return the used product to the seller at the moment he
buys a new unit, but only in proportion 1 to 1, a differentiated refuse
collection is environmentally friendly and it helps the recycling of the
materials, any other collection procedure is unlawful and will be subject to
the law in force.
Warranty
This warranty is valid for 2 year on materials and incorrect construction.
Only units with a fully filled in warranty slip and official till receipt
showing date of purchase will be considered. You must supply the entire unit
with accessories in the event of a warranty claim. We will inform you on
receipt whether the unit will be repaired or replaced. We accept no
responsibility for damage as a result of incorrect use of the unit. Breakages
of parts not due to defects ex-factory are not covered by this warranty.
Technical details
Sizes| 397 x 95 x 145 mm
Pump power| 12W
Max. Waterflow| 1000 L/h
Airflow| 200 l/h
SPS aquarium| 100-200 L
Mixed reef aquarium| 200-400 L
Fish only aquarium| 400-600 L
Dealer stamp
Date of purchase
Always keep proof of purchase, without purchase note no warranty!
Produced in China for:
www.aquadistri.com
Vlietweg 8 NL-4791 EZ Klundert