AQUADISTRI SuperFish Aqua Pro Feeder Instructions

AQUADISTRI SuperFish Aqua Pro Feeder

Product Information

The SuperFish Aqua Pro Feeder is an automatic feeding device designed for aquariums. It allows for easy and convenient feeding of fish at different times throughout the day. The feeder can be installed on the aquarium using a bracket or Velcro tape. It is important to keep the feeder dry and prevent it from falling into the aquarium to avoid water damage. The product is not covered by warranty for water damage.

The feeder is powered by batteries and has a battery level indicator to ensure reliable operation. It also features a manual feeding option, where pressing the Manual feed/Feed quantity button will activate the feed container for 10 seconds. The Aqua Pro Feeder allows for setting different feeding times, with options to set up to three feeding times per day. The feed quantity can also be adjusted manually. It is important to note that the product should be disposed of properly if no longer in use. It should not be discarded with normal household waste but rather handed in at an official collection center or returned to the dealer when purchasing a similar new product. Following the applicable rules in your country for the separate collection and recycling of electrical and electronic products is better for the environment and public health.

Product Usage Instructions

1. To install the Aqua Pro Feeder onto the aquarium:

   • Option 1: Use the provided bracket to attach the feeder to the aquarium.
   • Option 2: Use Velcro tape to secure the feeder onto the aquarium.
     Ensure that the feeder is securely attached and does not get wet or fall into the aquarium to avoid water damage.

2. To set feeding times:

3. 1. Refer to the current time displayed on the feeder.

4. Press the Setting Hours and Minutes buttons to adjust the feeding time.

5. Use the On/Off button to activate or deactivate each feeding time.

6. To adjust the feed quantity:
   Press the Manual feed/Feed quantity button to activate the feed container for 10 seconds. This will dispense the set feed quantity.

Note:
Start with the lowest setting for the feed quantity and adjust as needed.

Important Instruction

• Read carefully before usage.
• Only suitable for indoor use.
• Open battery cover and insert 3 AA (1.5V Alkaline batteries) and close the cover.
• Do NOT use rechargeable batteries.
• Replace the batteries when the battery indicator on the display shows only one dash. The feeder will otherwise stop feeding at short notice. However, the programmed settings will be retained.
• Always remove the batteries when you are not using the Aqua Pro Feeder for a longer period.

Setting and programming

Program the Aqua Pro Feeder before placing it on your aquarium. To switch the feeder on (or off), press the On/Off button for a long time (± 3 sec.). This is a safeguard against accidentally switching the feeder on or off.

Clock setting

• Press the Set button and the current time “00:00” will flash, press the HR button to set the hours.
• Press the MIN button to set the minutes.
• Press the Set button if you want to set the feeding times right away.

Programming feeding times

Up to three feeding times per day can be programmed and up to six different feed quantities can be given per feeding session. : ± 150 mg, : ± 300 mg, : ± 450 mg, : ± 900 mg, : ± 1800 mg and : ± 3500 mg feed (depending on the specific weight of the feed).

• Press 2x the Set button (or continue immediately after clock settings) and the top of the three feeding times will start flashing “ ”

• Press the HR button to set the hours and the MIN button to set the minutes of the first feeding time.

• Press the Manual feed/Feed quantity button to set the quantity of feed.
  Advice: Start with the lowest feed quantity setting and only increase it when it is clear that the fish are eating the feed fast enough.

• Press the Set button again to set the next feeding time “ ” and feed quantity ( , , , etc.).

• Repeat the above steps for the third feeding time “ ”.

• If you do not want to feed, make sure no feed quantity setting is selected.

• Then press the Set button to finalise everything.

Manual feeding
By pressing the Manual feed/Feed quantity button , the feed container will feed once for 10 seconds.

Installing the Aqua Pro Feeder onto the aquarium

The feeder can be installed on the aquarium using the bracket or the Velcro tape.

• Clamp the bracket over the bottom of the feeder. To do this, press the clamp so that it falls over the two recesses on the bottom of the feeder.
• The bracket can be rotated 360°, so you can always turn the feeder to the desired position.
• Attach the bracket over the edge of the aquarium and carefully tighten the screws so that the feeder is firmly in place.
• Make sure the opening of the feeder hangs above the aquarium so that the feed goes directly into the water.
• When using the Velcro tape, stick one part of the Velcro tape to the bottom of the feeder and the other to the desired surface. Make sure the Aqua Pro Feeder doesn’t get wet or drops into the aquarium. Water damage is not covered by the warranty!

Filling the Feed container
The Aqua Pro Feeder is suitable for pellets or sticks up to 3 mm.

• Simply fill the container via the lid at the top. After filling, close the lid.
• Press thee Manual feed button to transport the feed to the front of the feeder so that the feeder can feed directly at the set feeding times.

Maintenance

• Always remove leftover feed and dirt and clean the feed container regularly.
• Do NOT use soap or detergents.
• Make sure the container is completely dry before adding feed.

Warranty conditions

1 year manufacturer’s warranty on materials and construction defects. Devices must be returned complete with all components, accompanied with an official proof of purchase confirming a purchase date for any warranty claims. Incomplete devices of which parts are missing, and devices without proof of purchase are not eligible for warranty. After receiving and checking, we will determine whether the device will be repaired or replaced. For a device repaired or replaced under warranty, the remaining time of the original warranty period applies. Carefully read the instructions on installation, use and maintenance. Damage due to incorrect use, damage due to contamination or not cleaning the device are not covered by the warranty. Always keep the proof of purchase, without proof of purchase the warranty will be void!

Recycling

This symbol indicates that this product (if it is discarded) may not be disposed of with normal household waste. Instead it must be handed in at an official collection centre (e.g. HWRC). Or can be returned to the dealer when purchasing a similar new product. Follow the applicable rules in your country for the separate collection of electrical and electronic products. Separate collection and recycling are better for the environment, public health and reduces waste.

Contact Us

• Vlietweg 8, NL-4791 EZ Klundert The Netherlands
• www.aquadistri.com.

References

• Aquadistri | For A Successful Aquarium, Pond & Terrarium

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>