saxby GU10 Lampholder And Fast Fix Box Instruction Manual
- June 16, 2024
- saxby
Table of Contents
saxby GU10 Lampholder And Fast Fix Box
GU10 lampholder kit comes with a 4 way unique fast fix box to ensure quick and easy installation.
Thank you
Thank you for purchasing this accessory. Please read the instructions carefully before use to ensure safe and satisfactory operation of this product. Please retain these instructions for future reference.
Safety Precaution
Warning
This is a Class 1 product and must be earthed.
Please read these instructions carefully before commencing any work.
This unit must be fitted by a competent and qualified electrician.
Install in accordance with the IEE Wiring regulations and current Building
Regulations.
To prevent electrocution switch off at the mains supply before installing or
maintaining this fitting. Ensure other persons cannot restore the electrical
supply without your knowledge.
If you are in any doubt, please consult a qualified electrician.
If replacing an existing accessory, make a careful note of the connections.
Waste electrical products should not be disposed of with household waste.
Please recycle where facilities exist. Check with your local authority or
retailer for recycling advice.
Caution
-
Wire diameter smaller than 0.75mm2
Open the fast fix box, insert the cable, then refer to the corresponding wiring diagram. -
Wire diameter bigger than 0.75mm2
Open the fast fix box, use a screwdriver to press the cable camp to make hole bigger, then insert the cable and refer to the corresponding wiring diagram.
Customer Support
UK Manufacturer: BH17 7BY
EU Manufacturer: Brilliant AG,
Brilliant Strasse 1, D-27442 Gnarrenburg
www.saxbylighting.com