Lauben 600BB Desk Fan and Heater 2in1 User Guide
- June 16, 2024
- Lauben
Table of Contents
Lauben 600BB Desk Fan and Heater 2in1
SPECIFICATIONS AND FEATURES
- Model LBHFMDFH60BBA
- Voltage 100-240 V-, 50/60 Hz
- Input power 600W
- Noise level <50d B
- Recommended room area 10m’
SAFETY INSTRUCTIONS
GENERAL
PLEASE READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE. KEEP THIS USER GUIDE
FDR FUTURE REFERENCE. THIS APPLIANCE IS INTENDED FDR HOUSEHOLD USE ONLY.
- This appliance may be used by children aged 8 years or older and persons with reduced physical, sensory or mental abilities or lack of experience and knowledge, provided they are supervised or have been instructed in the safe use of the appliance and understand the potential hazards.
- Children must not play with the appliance. This is not a toy.
- Children under 3 years of age should be prevented from accessing the appliance unless they are permanently supervised.
- Children aged between 3 and 8 years must only switch this appliance on/off provided that it has been placed or installed in its intended normal operating position and that they are supervised or have been instructed in the safe use of the appliance and understand the potential hazards. Children aged between 3 and 8 must not insert the plug into the socket, regulate or clean the appliance or carry out user maintenance. Children must not use the appliance.
- Cleaning and maintenance by the user must not be carried out by unsupervised children.
- If the power cord is damaged, it must be replaced by the manufacturer, its service technician or a similarly qualified person to avoid
- dangerous situation. It is forbidden to use the appliance with
- damaged power cord or plug.
WARNING :
To prevent overheating, do not cover the heater. The heater must not be placed
just below an electrical socket. Do not use this heater in the immediate
vicinity of a bath, shower or swimming pool. Do not use the heater near any
water sources.
WARNING :
Do not use this heater in small rooms if they are occupied by persons who are
unable to leave the room on their own, unless permanent supervision is
provided.
WARNING
Some parts of this product may become very hot and cause burns. Special
attention must be paid to the presence of children and people with
disabilities. Do not use this heater if it has fallen. Do not use if there are
visible signs of damage to the heater. Use this heater on a horizontal and
stable surface. The heater is not designed for wall mounting.
WARNING :
To reduce the risk of fire, keep fabrics, curtains or any other combustible
material at least 1 m away from the air outlet.
SAFE USE OF THE APPLIANCE
- The appliance is intended for indoor use only. Do not use it outdoors.
- The appliance serves as a heater and fan for personal use in the home, office or similar areas. Do not use it for commercial purposes. Do not use it for any purpose other than that for which it is intended. It is forbidden to convert the appliance for another purpose. Do not use any accessories that are not recommended by the manufacturer.
- Follow the instructions in this User Guide.
- Do not move the heater if it is hot.
- Do not use the heater to dry laundry.
- The heater must not be used in transport vehicles.
- Do not leave the heater unattended while it is in use.
ELECTRICAL SAFETY
- Before plugging the power plug in, make sure that the voltage on the rating plate of the appliance matches the voltage at your mains socket. If in doubt, consult a qualified electrician.
- Make sure the heater is switched off before connecting. The main switch must be in position 0 (off).
- Only plug the power plug into a properly earthed mains socket.
- Do not use extension cords, multiple sockets or adapters.
- It is recommended to connect the appliance to a separate electrical circuit.
- Do not immerse the appliance, power cord or plug in water or any other liquid. There is a risk of electrical injury.
- Do not touch the plug with wet or damp hands, especially when plugging in or unplugging from the power supply.
- Route the power cord so that it does not touch hot surfaces, so that it cannot be stepped on or tripped over. The power cord must not be routed covered, e.g. under the carpet. Make sure that the power cord does not hang over the edge of the table or worktop, get tangled, bend excessively or touch sharp objects.
- Do not use the appliance with a programmer, timer, remote control system or any other system that automatically switches it on and off.
- Switch off the appliance, unplug the power plug from the mains socket whenever you leave it unattended, do not use it, before moving, cleaning or storing it. Allow the appliance to cool down before cleaning.
- The main switch at the rear of the appliance is used to switch off the appliance. Do not switch off the appliance by removing the power plug from the mains socket.
- Disconnect the power cord from the mains socket by pulling the plug, not by pulling the cord. There is a risk of damage to the power cord or the mains socket.
- The socket must be located close to the appliance and must be easily accessible.
SAFE PLACEMENT OF THE APPLIANCE
- Provide sufficient clearance around the appliance to ensure air circulation, at least 15 cm on each side.
- Do not place the appliance on unstable surfaces such as carpet, bed or tilted surfaces.
- Do not use the appliance in a place where flammable, volatile or explosive substances are used or stored.
- Do not block the ventilation openings of the appliance. There is a risk of overheating and subsequent damage.
SAFE APPLIANCE OPERATION
- Do not insert any objects into the holes in the front or rear part. There is a risk of electrical injury and damage to the appliance.
- Protect the appliance from drops or knocks.
SAFE MAINTENANCE
- Use only a dry cloth to clean the appliance. Follow the instructions in this User Guide.
- Never insert a wet or damp filter into the heater.
- If the appliance, power cord or plug are damaged or the appliance is not working properly, stop using it and contact an authorised service centre. Do not carry out the repair yourself.
- Neither the manufacturer, the importer nor the dealer accepts liability for any damage caused by incorrect assembly or use of the product.
PRODUCT DESCRIPTION
- Button : switching the heater on/off and selecting the operating mode
- Button : horizontal rotation of the heater
- Operation indicator light
- Air outlet
- Base
- Washable filter
- Rear protective grille
- Tip-over sensor
- Main switch
- Power cord
BEFORE FIRST USE
- Remove all packaging and foils and store them for later use.
- Check that the heater is complete and not damaged.
- Wipe the outer surface of the heater with a dry cloth.
PLACEMENT
- Place the heater on a firm, level and dry surface well away from the mains socket.
- Provide sufficient clearance around the heater to ensure air circulation, at least 15 cm on each side.
- To reduce the risk of fire, keep fabrics, curtains or any other combustible material at least 1 m away from the air outlet.
INSTRUCTIONS FOR USE
Basic use
- Plug the power plug into the mains socket and switch the main switch to the”I” (on) position. An audible warning sounds and the heater switches to standby mode.
- Press the button to switch the heater on. The heater starts in heater mode. The operation indicator light will turn red.
- Press the button again to switch the heater to fan mode. The operation indicator light will turn blue.
- Press the button again to switch the heater off and into standby mode. The operation indicator light goes out.
- Switch the main switch to “0” (off). Disconnect the power plug from the mains socket.
WARNING:
In heater mode, the front grille heats up. Do not touch the front of the
appliance.
Note :
If you switch the heater off in heater mode, the fan will run for about 20
seconds before it shuts off completely. This is a normal phenomenon when the
heating element cools down.
HORIZONTAL ROTATION OF THE HEATER
- Press the button while the heater is in heater or fan mode.
- The heater starts to rotate from left to right and vice versa.
- Press the button again and the heater will stop rotating.
OVERTURNING
- The heater is equipped with a tip-over safety sensor.
- If the heater falls during operation, the sensor detects the change in heater position and the operation is automatically stopped.
- Once the heater is in the operating position, it will start again. However, check that it has not been damaged.
OVERHEATING
- The heater is equipped with a thermal fuse to protect it from overheating.
- If the temperature sensor detects that the overheating temperature limit is exceeded, the thermal fuse is activated and the heater is switched off. In this case, the heater must be reset (more information below).
THERMAL FUSE RESET
- Disconnect the power plug from the mains socket for approximately 10 minutes to allow the heater to cool down.
- Check the heater and remove the possible cause of overheating or provide more space for air circulation.
- After 10 minutes, plug the power plug into the mains socket and switch on the heater.
If the heater does not start, switch it off and contact an authorised service centre.
CLEANING AND MAINTENANCE
Before cleaning and maintenance, switch off the heater, unplug the power plug from the mains socket and allow it to cool down.
WARNING:
Do not immerse the appliance, power cord or plug in water or any other liquid.
There is a risk of electrical injury.
Note :
Do not use any abrasive or chemical cleaners, benzene, solvents, alcohol, etc.
for cleaning.
- Wipe the outer surface of the heater with a dry cloth.
- Use a vacuum cleaner with the brush nozzle fitted to remove dust from the front and rear grilles.
- The filter should be removed and washed from time to time. Press the latch on the rear protective grille. Remove it and remove the filter. Wash the filter in warm water. Do not use any cleaning agents. Wring out the filter gently in your hand and let it dry freely. Do not use a dryer or hair dryer for drying. Do not dry the filter in direct sunlight. When the filter is dry, insert it into the heater and fit the rear protective grille.
WARNING:
Never insert a wet or damp filter into the heater. Serious damage to the
heater is imminent.
STORAGE
- Before storing, clean the heater according to the instructions above.
- Store the heater in its original box or other packaging in a dry and shady place out of reach of children and pets.
The symbol on the product or in the accompanying A documentation means that used electrical or electronic – products must not be disposed of with municipal waste. In order to dispose of the product properly, please take it to the designated collection points where it will be accepted free of charge. By disposing of this product correctly, youwill help conserve valuable natural resources and help prevent potential negative environmental and human health impacts that could result from improper waste disposal. For more details, contact your local authority or nearest collection point. Improper disposal of this type of waste may result in fines in accordance with national regulations.
Information for users on the disposal of electrical and electronic
equipment (corporate and business use):
For proper disposal of electrical and electronic equipment, ask your dealer or
supplier for details. Information for users on the disposal of electrical and
electronic equipment In other countries outside the
European Unlon:
The above symbol is valid only in European Union countries. For proper
disposal of electrical and electronic equipment elsewhere, ask your local
authorities or equipment dealer for details. All this is represented by the
crossed-out container symbol on the product, packaging or printed materials.
Please contact your dealer for warranty repairs. In case of technical problems and questions, please contact your dealer who will inform you of the next steps. Observe the rules for working with electrical equipment. The user is not authorised to disassemble the equipment or replace any of its components. There is a risk of electrical injury if the covers are opened or removed. Incorrectly assembling and reconnecting the equipment also exposes you to the risk of electrical injury.
The warranty period for products is 24 months, unlessotherwise stated. The warranty does not cover damage caused by non-standard use, mechanical damage, exposure to aggressive conditions, handling contrary to the User Guide and normal wear and tear. The warranty period for the battery is 24 months, for its capacity 6 months. For more
information on the warranty, please visit
www.elem6.com/warranty
Neither the manufacturer, importer nor distributor shall be liable for any
damage caused by the installation or improper use of the product.
EU Dadaration of Conformity
Elem6 s.r.o. hereby declares that the Lauben Desk Fan&Heater 2in1 600 BB
complies with the essential requirements and other relevant provisions of
Directive 2014/30/EU and 2014/35/EU. All Lauben products are intended for sale
without restriction in Germany, the Czech Republic, Slovakia, Poland, Hungary
and other EU member states. The full Declaration of Conformity can be
downloaded from
www.lauben.com/support/doc
Importers to the EU elem6 s.r.o., Braskovska 308/15, 16100 Prague 6, Czech Republic www.lauben.com
Manufacturer
TIGMON GmbH, YorkstraBe 22; 93049 Regensburg, Deutschland Printing errors and
changes to the User Guide are subject to change.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>