north states 5264 My Pet 38 Wide Petgate Passage Instruction Manual
- June 16, 2024
- north states
Table of Contents
5264 My Pet 38 Wide Petgate Passage
INSTRUCTIONS FOR MODELS
**5264 / 5268 / 5274 / 5285
**
IMPORTANT : PLEASE KEEP FOR FUTURE REFERENCE!
For helpful tips and instructions, please visit our website:
www.northstatesind.com or contact our
Customer Care department via email: Customer
Service@northstatesind.com
Phone:763-486-1754 or
Toll Free:800-848-8421
IMPORTANT! READ AND FOLLOW THESE INSTRUCTIONS CAREFULLY AND KEEP FOR FUTURE REFERENCE
Important Information
There is a gap between your gate frame and handle. This is not a defect. The
gap on your gate will close once it is properly mounted. Please check the gate
on a regular basis to ensure gate and parts are all in proper working order.
If the gate is used at the bottom of the stairs, please place towards the
front of the lowest stair.
Ensure gate is attached between two clean, structurally sound surfaces. Ensure
appropriate hardware is used when mounting in solid materials such as wood or
metal.
WARNING
- For use with pets only.
- STOP using when a pet can climb over or dislodge the gate.
- Install only with locking/latching mechanism securely engaged.
- To prevent falls, never use at top of stairs.
- This product will not necessarily prevent all accidents.
- NEVER leave pet unattended.
- This gate is to be used in openings 29.8″ to 38.1″ (75.69 cm to 96.77 cm).
- Periodically check all fasteners to be sure they are tight and secure, stop using gate if any parts are missing or become damaged.
A. Tension Knobs| G. Lower Extension Connector
---|---
B. Spindles (attached to gate frame)| H. Extension bar
C. Wall Cups| I. Gate Stopper
D. Tape Pads| J. Gate frame
E. Screws| K. Front Latch
F. Upper Extension Connector| L. Back Latch
To ensure safe operation, additional or replacement parts should be obtained
only from North States or its authorized distributors. Contact information
appears on the cover of these instructions.
Any damage to property during installation of your safety gate is the sole
responsibility of the end user.
Installation
Step 1
Measure the width of the opening and determine number of extensions needed for the gate.
Step 2
To add an extension, begin by removing both the upper and lower plugs from the side of the gate frame. You may need to use a athead screwdriver to remove the plugs. Figure 2A.
- Attach both the upper and lower extension connectors to the extension pole.
- Install the fully assembled extension by inserting the upper and lower extension connectors into the gate holes where you removed the plugs. Figure 2B.
- Replace both plugs. Place the tension knobs onto the spindles and insert the spindles into the holes located on the outside of the extension. Figure 2C.
Step 3
Attach gate stopper to the lower bar on the door frame.
NOTE : Insert gate stopper so the arrow is facing up and the stopper
knobs slide down.
Step 4
Insert the front latch (K) and the back latch (L) into the bottom of the pet
door frame. Ensure the release button on the latch is facing up. Firmly
connect them together to lock into place.
NOTE : Do not connect latch together prior to inserting the latch into
the pet door, as it will not come apart once it is connected. Step 5
Align and secure with wall cups onto your wall with tape pads or screws.
NOTE : Make sure the bottom of the gate frame remains completely flat on
the floor.
Step 6
Tighten both top and bottom tension knobs inward towards the gate.
To ensure safe installation with proper gate installation, continue to tighten
tension knobs until the gap between the upper latch and the upper gate frame
housing is eliminated.
Operation
OPENING THE GATE:
- Slide triangular button located within the gate handle.
- While holding button, lift the handle upwards.
CLOSING THE GATE:
- Manually swing the gate closed with the handle in the upright position.
- Return handle to the closed position.
You will hear a “click” when the handle is securely engaged.
Swing Control Operation
Rotate the knob down on the gate stopper to determine the direction the gate door will swing. Gate opens in both directions when gate stopper is not rotated.
Pet Door Operation
TO UNLOCK
Squeeze and twist the front center knob located below the pet door. As you
twist, the knob will line up with the arrows on the right or left sides of the
knob. The pet door will move freely in both directions for your pet to pass
through.
TO LOCK
Squeeze and twist the front center knob located below the pet door. As you
twist, the knob will be in the upright position, keeping the door securely
locked.
WARNING
Make certain that the pet door is securely locked in the closed position if
using with a child 6-24 months of age.
Care
CLEANING : Clean the safety gate using warm water and a mild detergent. Use a soft cloth or sponge to avoid scratches. Never use solvents or chemicals to clean the safety gate.
Distributed in the United States by
North States Industries, Inc.
5455 Highway 169 N
Plymouth, MN 55442
www.northstatesind.com
Manufactured in China
Documents / Resources
|
north states 5264 My Pet 38 Wide Petgate
Passage
[pdf] Instruction Manual
5264 MyPet 38 Wide Petgate Passage, 5264, MyPet 38 Wide Petgate Passage, Wide
Petgate Passage, Petgate Passage, Passage
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>