Kinderkraft Comfort UP i Size Car Seat User Guide
- June 16, 2024
- Kinderkraft
Table of Contents
Kinderkraft Comfort UP i Size Car Seat
Introduction
This user guide is provided for the COMFORT UP i-Size car seat, model COMFORT UP i-Size, which complies with ECE R129.03 regulations, version 1.0. It is critical to read this manual carefully before using the car seat for the first time as the safety of your child is your responsibility and failure to read these instructions may have consequences for your child.
Specifications
- Model: I-LITE
- i-Size compliant
- ECE.R129.03 certified
- Version: 1.0
| Child Length | Car Seat Orientation | Car Seat Fixation | Child Fastening |
|---|---|---|---|
| 76cm – 105cm / ≤18kg | Forward facing travel | 3-point seat belt | Internal |
harness
100cm – 150cm| Forward facing travel| 3-point seat belt| 3-point car seat belt
Product Usage Instructions
Parts of the Car Seat
- Headrest
- Backrest
- Hip belt guide
- Removable internal belt cushions
- Internal belt
- Internal belt buckle
- Buckle pad
- Internal belt adjustment knob
- Internal belt adjustment strap
- Seat of the car seat
- Headrest height adjustment lever
- Shoulder strap guide
- Car seat buckle
- Seat reducer
Application
The car seat is designed, tested, and approved in accordance with the
regulations of the UN/ECE Regulation No.129 for the approval of improved child
restraint systems (UN/ECE R129/03).
Safety Instructions
Take a few minutes to read this manual to ensure your child’s safety. Many avoidable injuries are caused by reckless and incorrect use of the car seat. The car seat is designed for use on front-facing car seats only and should not be installed on rearward or sideways facing seats or car seats. If a car seat is installed on the front seat, the frontal airbag must be deactivated. It is advised to install the car seat on the rear bench of a car only. Refer to your vehicle’s manual for instructions on using a car seat with a child car seat.
WARNINGS:
- Take a few minutes to read this manual to ensure the safety of your child. Many avoidable injuries are caused by reckless and improper use of the car seat.
- The car seat should only be installed on the back seat of a car. The front airbags can cause serious injury or death if activated. We recommend installing the car seat rear-facing.
- Instructions regarding the suitability of a car seat for use with a child restraint system can be found in the car’s manual.
- The child should be properly secured in the car seat with the seatbelt. Ensure that the seatbelt is positioned correctly on the child and not twisted. Do not dress the child in thick clothing under the seatbelt.
- Regularly check the car seat for any damage or wear and tear. Replace any damaged or worn-out parts immediately. Only use original spare parts provided by the manufacturer.
- Do not modify or alter the car seat in any way. Any modifications can compromise the safety of your child.
- Do not expose the car seat to extreme temperatures or direct sunlight for prolonged periods. Excessive heat can cause burns to your child. Protect your child and the car seat from the sun.
- Ensure that all parts of the car seat work properly. The components of a child car seat should never be greased or oiled.
- Keep small parts out of reach of children. Children can choke on small parts or play with the seatbelt.
Use of Seat Reducer
The seat reducer (position 15) improves comfort and provides extra support
for small children. It is recommended to use both the lower part and the upper
part that serves as a head cushion for the child until the child needs more
space in the car seat. The seat reducer should then be removed.
Installation of Seat Reducer
To install the seat reducer, follow these steps:
- Place the lower part of the seat reducer in the car seat (fig. C.1).
- Attach the upper part of the seat reducer to the lower part using the designated fasteners (fig. C.2).
- Ensure that the seat reducer is securely attached and does not move or shift during use (fig. C.3).
Usage Instructions
Using the Seat Reducer
The seat reducer improves comfort and provides extra support to small
children. It is recommended to use both the lower part and the upper part that
serves as a cushion for the child’s head until the child requires more space
in the car seat. The seat reducer must then be removed.
Mounting the Seat Reducer
- Unfasten the internal harness by pressing the red button on the buckle.
- Place the seat reducer in the car seat so that it fits against the side edges.
- Adjust the position of the internal harness. Ensure that the harness is not twisted.
- Place the upper part of the seat reducer or the headrest with the help of a strap.
Securing the Child with the Internal Harness
- Fully loosen the harness by pressing the button and pulling the harness straps.
- Unfasten the buckle and place the harness straps on the side edges of the car seat.
- Place the child in the car seat and adjust the headrest to the length of the child.
- Buckle the two clasps together until you hear a “click.”
Tightening the Internal Harness
- Pull the shoulder straps to remove any slack from the waist area so that the harness lies flat.
- Tighten the internal harness with the adjuster until the belt lies flat and close against the child’s body.
- Note: The straps of the hip section of the internal harness should be placed as low as possible on the child’s hips. Ensure that the internal harness is not twisted.
Using the Car Seat
Adjustment of Internal Belt including Headrest
To adjust the internal belt and headrest, follow these steps:
- Place the child car seat on the vehicle seat.
- Place the child in the car seat and check the height of the headrest. Repeat the height adjustment of the headrest if necessary until the optimal height is achieved.
Securing the Child with Internal Harness Belts
To secure the child in the car seat using the internal harness belts,
follow these steps:
- Place the child in the car seat (fig. B.6).
- Fasten the internal belt buckles and ensure they are securely locked (fig. C.7).
- Adjust the length of the internal belts so they fit snugly on the child’s shoulders and hips. Pull the adjustment strap until you hear a click (fig. B.7).
Tensioning Internal Belt
To ensure proper tensioning of the internal belt, follow these steps:
- Pull the adjustment strap to tighten the internal belt (fig. D.1).
- Check that the internal belt is snugly tightened around the child’s body without causing discomfort or restricting movement (fig. D.2).
Installation in the Vehicle
To install the car seat in the vehicle, follow the instructions provided in
the car seat’s manual.
Maintenance Instructions
Removing the Cover
- Remove the seat reducer if used.
- Remove the internal harness if used.
- Remove the shoulder cushions.
- Remove the cushion from the internal harness buckle.
- Remove the cover from the headrest and edge of the seat.
- Note: Frequent removal of the cover is not recommended. To reinstall the cover, reverse the steps above.
Cleaning
Regularly check all important parts of the car seat. Mechanical parts should work perfectly. Use only the original cover, as it is an important part of the safety provided by the side of the car seat. Do not use the car seat without the cover.
Clean the cover with a neutral detergent and warm water. Do not machine wash; centrifuge and dry in a tumble dryer are not recommended. Remove the foam that is in the cover on the backrest of the seat. Plastic parts can be cleaned with water and diluted soap. Do not use aggressive cleaning agents (such as solvents). The internal harness can be cleaned in lukewarm water. Warning! Metal fasteners must never be removed from the harness.
Contact Information
If you have a problem with the product you received, contact Kinderkraft in the most convenient way for you:
International contact: [email protected] | +44 20 4525 0748
Manufacturer: 4Kraft Sp. z o.o., ul. Tatrzańska 1/5, 60-413 Poznań, Poland
FAQ
Can I install the car seat in the front seat of the car?
No, it is recommended to install the car seat on the back seat of the car. The front airbags can cause serious injury or death if activated.
How do I adjust the headrest?
Place the child in the car seat and adjust the height of the headrest until the optimal height is achieved.
Can I use the car seat with thick clothing on the child?
No, do not dress the child in thick clothing under the seatbelt. This can affect the proper positioning and effectiveness of the seatbelt in case of an accident.
How do I adjust the headrest height?
Place the child in the car seat and adjust the headrest height as needed to reach the optimal height for the child.
What should I check before every car journey?
Always ensure that the car seat is installed correctly and that the internal harness is not twisted and is properly secured.
Can I wash the car seat cover in a washing machine?
No, it is recommended to clean the cover with a neutral detergent and warm water only, without machine washing.