SMAJAYU R26 base Radio RTK Instruction Manual
- June 16, 2024
- SMAJAYU
Table of Contents
R26 base Radio RTK
Instruction Manual
R26 base Radio RTK
R26 base rover
simple setup steps
Preparation before setting up
1.1 Make sure that the two R26s have enough power (the power light is always
on after startup, indicating that the power is sufficient)
1.2 Connect the radio antenna and press the power button to start R26
1.3 R26
needs to work in an open and unobstructed place to ensure accuracy
Set base
2.1 Use the Ally pad app to connect to the base via Bluetooth (note that the
SN number is the Bluetooth name, you can check the SN at the bottom of the
machine): Device –> Communication –> Device Para –> Select your device number
(same as SN) –> Connect.
2.2 Set R26 base as base (after the setting is completed, please wait 2 to 3
minutes before clicking Stop to disconnect, then connect another R26 and set
it as rover. Because it takes some time to update the device information):
Device –> Base –> Set base station startup parameters –> Set Base Startup,
Please remember the protocol and frequency you set so that you can set the
rover’s frequency and protocol based on the base’s protocol and frequency. The
protocols and frequencies of the base and rover must be consistent to obtain a
fixed. State.
Set up rover
3.1 Connect to R26 rover via Bluetooth using Ally pad app：Device –>
Communication –> Device Para –> Select your device number (same as SN) –>
Connect.
3.2 Set R26 rover as rover：Device –> Rover –> Set rover startup parameters –>
Set Rover Startup,
Please note that if you use radio RTK for correction, the radio protocol and
frequency when you set up the rover must be the same as your base. If you want
to use another brand of radio base station, please pay attention to whether it
supports the R26 radio protocol and frequency.
Tip: R26 V2 uses Lora radio, so the protocol is different from R26 V1. If
your device is R26 V2, please select CSS for the protocol.
Ntrip Correction: Log in to your CORS account
Survey
4.1 Create a new project and set the coordinate system parameters: Project –>
Project Manager –> New –> Coordinate systems parameters
4.2 Set the correct antenna height
4.4 For detailed measurement steps and function
description, please refer to the ‘R26 rover user manual’.Address: Room 213-214, Building 1, Mingling Science Park,
No. 88, Zhuang North Road, Taoyuan Street,
Nanshan District, Shenzhen
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>