SAGE LU MEI R11 Ultrathin Touch Slide RF Remote Controller Instruction Manual
- June 4, 2024
- SAGE LU MEI
Table of Contents
Ultrathin Touch Slide RF Remote Controller
Model No.: R11,R12,R13
Touch color slide/1-3 color/Wireless remote 30m distance/CR2032
battery/Magnet stuck fix
Features
- Apply to a single color, dual color or RGB LED controller.
- Ultra-sensitive color adjustment touch slide.
- Each remote can match one or more receivers.
- CR2032 battery-powered.
- Operate with LED indicator light.
- Magnet on the back which can be easily stuck on back holder or any metal surfaces.
Technical Parameters
Input and Output
Output signal| RF 2.4GHz
Working voltage| 3VDC CR2032
Working current| ＜5mA
Standby current| ＜10μA
Standby time| 1 year
Remote distance| 30m(Barrier-free space)
Environment
Operation temperature| Ta: -30 O C ~ +55 O C
IP rating| IP20
Safety and EMC
EMC standard (EMC)| ETSI EN 301 489-1 V2.2.3
ETSI EN 301 489-17 V3.2.4
Safety standard(LVD)| EN 62368-1:2020+A11:2020
Radio Equipment(RED)| ETSI EN 300 328 V2.2.2
Certification| CE,EMC,LVD,RED
Warranty
Warranty| 5 years
Weight
Gross weight| 24g
Net weight| 64g
Mechanical Structures and Installations
To fix the remote, three options are offered for selection:
Option 1: stuck the remote on any metal surfaces directly.
Option 2: fix the remote’ back holder on the wall with two screws.
Option 3: adhere the remote’ back holder to the wall with a paster.
Match Remote Control (two match ways)
The end users can choose suitable match/delete ways. Two options are offered for selection:
Use the controller’s Match key
Match: Short press the match key, and immediately press on/off key on the
remote.
The LED indicator fast flash a few times means the match is successful.
Delete: Press and hold the match key for 5s to delete all match, The LED
indicator fast flash a few times means all matched remotes were deleted.
Use Power Restart
Match: Switch off the power, then switch on the power, repeat again. An
immediately short press on/off key 3 times on the remote. The light blinks 3
times means the match is successful.
Delete: Switch off the power, then switch on the power, repeat again. An
immediately short press on/off key 5 times on the remote. The light blinks 5
times means all matched remotes were deleted.
Key function
- R11 1 zone dimming remote
- R12 1 zone CCT remote
- R13 1 zone RGB remote
Safety information
-
Read all instructions carefully before you begin this installation.
-
When installing the battery, pay attention to the battery’s positive and negative polarity.
After a long time without the remote control, remove the battery.
When remote distance becomes smaller and insensitive, replace the battery. -
If no response from the receiver, please re-match the remote.
-
Gently handle the remote, beware of falling.
-
For indoor and dry location use only.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>