NORA LIGHTING M1 Round LED Recessed Down Light Instruction Manual

June 16, 2024
NORA LIGHTING

NORA LIGHTING M1 Round LED Recessed Down Light

Specifications

  • Product Name: NM1-PRDC 1 M1+ Round LED Recessed Downlight
  • Power Supply : Main Power
  • Installation: Requires a local electrician
  • Safety Features: Grounding the fixture, and turning off the power supply before installation.

Installation Instructions

  • READ BEFORE ATTEMPTING INSTALLATION
  • ALWAYS TURN OFF THE MAIN POWER BEFORE INSTALLATION
  • INSTALLATION SHOULD BE CARRIED OUT BY YOUR LOCAL ELECTRICIAN

WARNING – Risk of shock. An electric current can cause painful shock or serious injury unless handled properly. For your safety, always remember to turn off the power supply at the fuse or circuit breaker box before you install the fixture and ground the fixture to avoid potential electrical shocks and to ensure reliable starting.
WARNING – Risk of cuts. Some metal parts in the fixture may have sharp edges. To prevent cuts and scrapes, wear gloves when handling the parts.
IMPORTANT – This equipment is intended to be installed only by qualified personnel. The installation must be made per the current edition of the National Electric Code and all applicable state and local building codes. The final installation must be approved by the appropriate qualified electrical/building inspector(s). Improper installation may result in a fire or electrical hazard. Be sure the electrical power to the circuit has been disconnected before installing this electrical system.

PACKAGING CONTENTS

JUNCTION BOX INSTALLATION

TURN OFF THE MAIN POWER BEFORE INSTALLATION

  1. Make sure the power is off.
  2. Locate a suitable position to install the luminaire and cut a 1-15/16″ diameter hole in the ceiling. (Figure 1)
  3. Run power supply leads through the hole. Use NMD90 Romex or BX Cable.
  4. Open the remote junction box cover and remove the appropriate knockouts.
  5. Insert power supply leads through the knockout and secure with a cable connector. (not included)
  6. Using push-in connectors, connect the same coloured power supply lead wires to the junction box wires. (Figure 2)
  7. Place all wiring and connections back into the remote junction box and close the cover.
  8. Place the junction box through the mounting hole and secure it (Figure 3).

LUMINAIRE INSTALLATION

  1. Connect the LED module to the junction box by inserting and twisting the male/female connector. (Figure 1)
  2. Push spring-loaded clips on the fixture upwards and insert the fixture base into the mounting hole. Release the clips and the fixture will be pulled flush to the ceiling. (Figure 2)
  3. Do not place the junction box above the luminaire. (Figure 3)
  4. Once assembly is complete, turn on the power to confirm the fixture is working properly.

FAQ

  • Q: What should I do before attempting installation?
    • A: Always turn off the main power before installation to prevent electric shocks. Installation should be carried out by a local electrician.
  • Q: How do I connect the LED module to the junction box?
    • A: Insert and twist the male/female connector of the LED module into the junction box.
  • Q: How do I mount the fixture flush to the ceiling?
    • A: Push the spring-loaded clips on the fixture upwards, insert the fixture base into the mounting hole, and then release the\ clips.
  • Q: Can I place the junction box above the luminaire?
    • A: No, ensure that the junction box is not placed above the luminaire.

6505 Gayhart Street, Commerce, CA 90040
Tel 800.686.6672 | www.noralighting.com | e-mail: nora@noralighting.com
© 2022 Nora Lighting, Inc. All rights reserved. Instructions are subject to change without notice.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

NORA LIGHTING User Manuals

Related Manuals