CREATE B081B3H9V1 Vertical Steam Iron Up Stand User Manual

CREATE B081B3H9V1 Vertical Steam Iron Up Stand

Thank you for choosing our product. Before using this device for the first time, please read the following operating and safety instructions carefully.
With this manual you can learn the functions of this device. Keep this manual for future reference or if you need to pass it on to a third party.

IMPORTANT SAFEGUARDS

Before using this electrical appliance basic precautions should always be followed:

• Ensure that the voltage indicated on the Technical Specification matches the mains voltage before plugging in the appliance.
• The appliance must be earthed.
• Never lift up, carry or unplug the appliance by pulling from the power cord.
• The steam is extremely hot and can burn. Please, handle with care.
• Never put the iron into operation if it does not have water.
• Children should be supervised to ensure that they don’t play with the appliance.
• This appliance can be used by children and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved.
• Do not place the coffee maker on hot surfaces or next to open fire, as it can cause damage to the appliance.
• Remove the plug from the power outlet before cleaning or when idle. Allow the appliance to cool down completely before removing and/or attaching components, and before cleaning.
• Do not pick up or operate the appliance if the power cord or plug is damaged, or if the iron is malfunctioning or has been dropped or damaged in any way. In case of damage, contact the after-sales service. A damaged cord or plug must be replaced only by the manufacturer or a qualified person to avoid injury.
• Do not use any accessories not recommended by the manufacturer, as it may cause injury to persons or damage to the appliance.
• Place the appliance on a flat surface or table, do not hang the power cord over the edge of the table or counter.
• Make sure the power cord does not come into contact with the hot surface of the appliance.
• Some parts of the appliance get hot when in use, avoid direct contact.
• Never immerse the power cord, plug or power base of the iron in water or other liquids. In the event that the appliance falls into water, immediately unplug it from the mains and have it checked by an expert before using it again. It can cause fire, electric shock, injury or death.

CHARACTERISTICS

• All aluminum heater, fast heat conduction, continuous steam more uniform.
• Nozzle 9 hole stainless steel panel, smooth, no damage to clothing.
• 1.6l water tank, to meet the needs of long ironing.
• Lateral drainage design, convenient and fast scale removal.
• Dual dry ironing resistant design, more secure overall protection.
• Simple hook, convenient and fast, strong and durable.
• Round bar, firm and stable for a better experience.

COMPONENTS

1. Steam nozzle
2. Sprinkler rack
3. Steam hose
4. Telescopic rod
5. Adjustable lifting and shrink-ing bar buckle
6. Switch knob
7. Water tank
8. Body
9. Power cord plug
10. Drainage valve button

Tips : for better ironing experience and protection of your clothes, it is advisable to use pure water or distilled water.

ACCESSORIES

TROUSERS BRUSH
Usage: for the customers who need the trouser line or axis, hold the upper part of the fabric with your hand or a clamp when ironing, then hold the clothes or trousers with trousers seam clamp, move up and down to press the fabric. Brush ironing with shower nozzle, it can clean the hair and other things on clothes while ironing.

PROTECTIVE GLOVES
Usage: if you need to iron the clothes with your hands, please wear the heat resistant gloves on your hands holding the clothes to avoid hand burns.

ACCESSORY FOR SHIRT COLLARS
Usage: This accessory is used to help you when ironing shirt collars to keep their shape perfectly.

INSTALLATION

Install the telescopic pole

1. Open the package and take out the host and accessories.
2. Insert the thick end of the telescopic rod directly into the socket of the telescopic rod of the body, and press the telescopic rod in place.

Adjust the height of the telescopic pole
Loose the adjusting buckle of the telescopic pole, vstretch and adjust the four telescopic poles to an appropriate height, and then lock the adjusting buckle of the telescopic pole.

Install the hook and place household hangers
Insert the connector at the lower end of the hook at the top of the telescopic rod, and hold the extension rod to press the hook into position. Place the household coat hanger in its place. The rack can be rotated 360°.

Nozzle placed
Place nozzle in nozzle hook.
Note: Do not hang the steam hose on the hook to prevent the steam nozzle from falling.

Falling can hurt people or damage steam sprinklers.

Installation and removal of trouser seam clips
Installation: Let the groove of the pants seam clip on one corner close to the nozzle bottom protruding installation piece, and then follow this angle gently upward.
Remove: first tilt the seam clamp, then gently pull down the seam clamp to remove it.

Water tank filling
Remove the water tank from the main engine, unscrew the nut at the bottom of the water tank and fill it with water, cover the nut and tighten it, place the water tank in its original position and ensure no deviation.

Note : the water tank of this product can only be filled with cold water. Please avoid injecting hot water into the water tank. At the same time, do not add perfume, vinegar, starch or other chemicals in the cold water to avoid damaging the product.

Tips : for a better ironing experience and protection of your clothes, you are advised to use pure water or distilled water.

APPLICATION METHOD

IRONING

1. Insert the power cord plug into the live socket.
2. This iron has two steam adjustment modes. You can choose the appropriate steam mode according to the material and thickness of your clothes.
3. The hook of this product can be used to hang ordinary household clothes hangers. Clothes can be hung on the clothes hangers. When you are not using the garment steamer, put the steam nozzle on the nozzle rack.

TURN OFF
When you finish ironing, turn the switch counter clockwise to the “off” to turn off the power of the unit, and remove the plug from the socket after confirming that the power indicator light is off.
Tips : If you do not use the steam iron for a long time, the remaining water in the machine is liable to deteriorate and cause bacteria, please cut off the power until the water is cooled, and then unscrew the drain valve to discharge the remaining water.

CLEANING AND STORAGE

1. Always unplug the power cord before cleaning and maintenance.
2. Do not rinse the machine with water directly, but wipe it with a soft cloth with a little neutral detergent and then wipe it dry. Do not clean the machine with solvents such as gasoline.
3. After cleaning and maintenance, it must be fully dry before power on or collection.
4. When it is not in use for a long time, please clean the product and remove the steam hose from the hanger after it is dry. Then, fold the telescopic rod with hanger and remove it from the host machine.

CLEANING METHODS

• Prepare 1000 g of pure water to be injected into the water tank, and then add 2 g of detergent. After it is fully dissolved, pour it into the water tank of the machine. The machine has to be heated at the steam level for 20-30 minutes, then unplug it and let it cool for 30 minutes.
• Place the machine on the sink or waste water bucket, turn off the drain valve knob counter clockwise, (do not use sharp objects to scrape the inner wall of heating body to remove dirt) until no residual water flows out from the drain, tighten the drain valve knob, and place the machine back in place.
• Pour the remaining solvent out of the tank and rinse.
• We recommend that you remove the scale once a month.

CONSIDERATIONS

Note : All contents of this section are related to safety, please be sure to comply with it. The considerations in this section are solely for the proper use of the product.
The notes explain the hazards, the extent of the hazards and the possible accidents.

1. Do not use other parts without the permission of the manufacturer. If the machine breaks down due to this reason, the warranty will automatically terminate. The manufacturer shall not be liable for any loss of life or property.
2. Please check whether the product is damaged and whether the accessories are complete after dismantling the package.
3. This product is not applicable to children and those without capacity.
4. In case of failure, the power plug should be pulled out immediately, and the defective product should not be placed in the working state.
5. If the power cord is damaged, it must be replaced by the professional personnel of the manufacturer, its maintenance department or similar department to avoid danger.

Any content bearing the logo must be prohibited, otherwise it may cause damage to the product or endanger the personal safety of the user.

All contents bearing the mark must be handled in strict accordance with the requirements, otherwise it may cause damage to the product or endanger the personal safety of the user.
All the contents with the logo are the parts that users must pay attention to, otherwise improper operation will cause product damage or other losses.

Do not place in water or flush with water.

| Do not start the power and add water first to prevent dry burning.
---|---
This product is not allowed to be used outdoors| Durante el uso, no fuerce la manguera de vapor para doblar o bloquear la salida de aire.
It is suggested that during the use of this product, do not remove the clip of trousers to avoid burns.| In the process of using this product, please do not touch the heating position or the nozzle to iron the surface. When dumping the surplus water, please cut off the power and wait for the water to cool down to avoid scalding.
Users are not allowed to leave during the working period of this product. Care should be taken when using appliances to prevent the risk of steam splashing. When filling liquid and cleaning, should remove the power plug.| Do not inject hot water into the tank, so as not to cause deformation of the tank.
---|---
Pay attention to the safety of plug, socket and power supply. Do not drag or pull the plug.| This product is only used with grounding wire socket.

Note: in order to avoid hazards arising from the incorrect resetting of the thermal circuit breaker, the appliance shall not be powered by an external switching device, such as a timer, or connected to a circuit that is regularly switched on or off by a common component.

Do not put the product on the table, chair or other unstable surface to avoid the risk of product dumping.| This product is suitable for ordinary tap water. If your local tap water is very hard, it is recommended to use bottled or bottled drinking water, or pure water.
When the product just starts to work, there will be a small amount of hot condensed water from the steam hole, please pay attention to safety.| When using this product, please try your best to keep the nozzle panel working along the vertical direction, and reduce the downward horizontal direction of the nozzle panel, so as to avoid condensation water droplets.

COMMON PROBLEMS

Please check the following points before entrusting the maintenance department to make repairs

plugged into the power supply

The upper power switch is damaged Thermal fuse damaged

| Plug the power cord into a live socket Please ask a professional to check it
No steam but the switch light is on| There is no water in the tank Thermal fuse damaged Thermostat damage| Fill the tank with the right amount of water Please ask a professional to check and maintain

Please ask a professional to check and maintain

Steam is too small| The voltage is too low Scale clogs up steam pipes| Please avoid using this product during peak hours

Please refer to “scale removal method” in the instruction manual for scale removal

Nozzle is leaking| Nozzle air hole downward or nozzle below the water level of the tank Nozzle broken| Please lift nozzle to water level of water tank above or the nozzle along the vertical direction of operation please professional inspection and maintenance

Watertank leaking

| The hole nut is not tightened or the water tank is broken

Steam hose is not well vented or blocked

| Tighten the water injection hole nut or ask a professional for maintenance

Avoid steam hose folding or professional maintenance

The whole machine Is leaking| Drain valve knob or sewage outlet knob is not tightened

The tilt Angle is too large when the machine is working or moving Drain knob or drain knob or internal pipe damage

| Please tighten the drain valve knob or sewage outlet knob.

Avoid excessive inclination Angle when the machine is working or moving Please ask a professional to check and maintain

Deformación del depósito| The tilt Angle is too large when the machine is working or moving| Please replace the water tank (standard water tank)
It is a normal phenomenon that a big amount of air flow generated by steam impinges on the nozzle, and the sound of “puff” is occasionally heard at the nozzle. You can use the steam iron as usual.

The water in the boiler will produce the sound of “purr” due to boiling, which is a normal phenomenon.

In compliance with Directives: 2012/19/EU and 2015/863/EU on the restriction of the use of dangerous substances in electric and electronic equipment as well as their waste disposal. The symbol with the crossed dustbin shown on the package indicates that the product at the end of its service life shall be collected as separate waste. Therefore, any products that have reached the end of their useful life must be given to waste disposal centres specialising in separate collection of waste electrical and electronic equipment, or given back to the retailer at the time of purchasing new similar equipment, on a one for one basis. The adequate separate collection for the subsequent start-up of the equipment sent to be recycled, treated and disposed of in an environmentally compatible way contributes to preventing possible negative effects on the environment and health and optimises the recycling and reuse of components making up the apparatus. Abusive disposal of the product by the user involves application of the administrative sanctions according to the laws.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>