LAMPEHUSET 50421-003-71 Interior Track Light Instruction Manual
- June 4, 2024
- LAMPEHUSET
Table of Contents
LAMPEHUSET 50421-003-71 Interior Track Light
Package contents
(parts are not to scale):
| Part | Description | Quantity |
|---|---|---|
| A | Light track 1.0 M | 1 |
| B | Wall expansion particle | 2 |
| C | Self-Tapping screw | 2 |
| D | Spotlight | 3 |
Warning:
- Only use bulbs as directed on the label on the lamp.
- Turn off the lamp before replacing the bulb and wait until the bulb has cooled. Take special care to touch the lamp when the lamp is Iii. II can be hot.
Pre-Installation
PLANNING THE INSTALLATION
Read all instructions before assembly and installation. Before starting the
installation of the fixture or removal of a previous fixture, disconnect the
power by turning off the circuit breaker or by removing the fuse at the fuse
box. To avoid damaging this product, assemble it on a soft, non-abrasive
surface such as carpet or cardboard.
TOOLS REQUIRED
Installation
(Make sure to turn off the main power)
Step 1
Drill holes in the installation plane according to the installation holes of
the track, and fix the guide rail on the installation surface with the rubber
plugs and self-tapping screws in the accessory kit;
Step 2
Remove screw A with a screwdriver, open the upper cover of the power
connector, connect the mains to the rail power connector, confirm that the
live wire (L), neutral wire (N), and ground wire are connected reliably, then
Reinstall the upper cover, and finally lighten the screws B and
C.
Solution A and B for entering of the power cable
Step 3
Push the cover of the spot head backward.
Step 4
Install the recommended bulb.
Step 5
Pull back the cover of the spot head.
Step 6
Install the light head into the track.
Operation
- Turn on power at the circuit breaker or fuse box.
- Turn the light switch on to activate the fixture.