PANDUIT CCPL2H Hole Cable Cleat Instruction Manual
- June 15, 2024
- PANDUIT
Table of Contents
Instruction Manual
Aluminum
and Plastic 2- Hole
Cable Cleat
CCPL2H Hole Cable Cleat
Cable Cleat for the Protection and Support Of Cables in a Flat Arrangement
INSTALLATION INSTRUCTIONS CCAL2H and CCPL2H Family of Cable Cleats
| TO REDUCE THE RISK OF INJURY, USER
MUST READ INSTALLATION INSTRUCTIONS
BEFORE ATTEMPTING TO INSTALL
---|---
| NOTE: In the interest of higher quality and value, Panduit products are
continually being improved and updated. Consequently, pictures may vary from
the enclosed product.
NOTE: Updates to this Installation Instructions may be available. Check
www.panduit.com for the latest version of this
manual.
Preparing for Order
| Step | Picture | Description |
|---|---|---|
| 1 | Contact Panduit Sales for assistance with Cleat and hardware selection. | |
| 2 | Measure actual diameter of the cables. Select a cleat part number based |
on the actual diameter of the cables.
3| | Measure height of the ladder rung. Procure M10 or 3/8” washers, nylon-
insert locknuts, and hex bolts with sufficient length to pass through the
ladder rung and cleat with the cables installed.
Dock washers can be used to span the opening at the bottom of the rung if
there is insufficient clearance between the flanges.
Cleat Assembly
| Step | Picture | Description |
|---|---|---|
| 1 | Position one of the two identical cleat components over the |
appropriate holes in the rung.
2| | Place cable in the cup of the cleat.
3| | Assemble top of cleat over the cable, nesting the antirotation features
in the two halves of the cleat.
3A| | OPTIONAL. 2 Hole cleats may be stacked on each other up to three levels
total. Stacking will affect stud/bolt length. This step
should only be performed if specified in engineering instructions or drawings
for your application.
4| 
|
Assemble M10 or 3/8” mounting hardware through bolt holes. Tighten bolts to
90in-lbs [10.2Nm].
Ensure the top remains level during tightening. The position of the nut and
bolt may be flipped. Follow engineering instructions for your application.
END| 
|
Installed product.
Email:
techsupport@panduit.com
EU Website:
www.panduit.com/emea
EU Email:
emeatoolservicecenter@panduit.com
www.panduit.com
Panduit Corp.
USA Technical Support
Tel: 800-777-3300
Panduit Europe • EMEA Service Center
Tel: +31 546 580 452 • Fax: +31 546 580 441
RW318
Rev. AB [12-2022] © Panduit Corp. 2022
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>