STOREMIC SMBTC01 Toilet Seat Instruction Manual

Table of Contents

Specifications:

Extending the Lifespan of the Soft-Close Toilet Seat:
To extend the lifespan of the soft-close toilet seat, avoid slamming it shut.
Maximum Weight Capacity:
Do not exceed the maximum weight capacity of 150KG.
Protecting the Toilet Seat from Sunlight:
Avoid exposing the toilet seat directly to sunlight for long periods. Also, prevent any direct strong light or high temperature from reaching the seat.

Tools Needed (Not Included):

Installation Steps

Step 1:

Insert the expansion anchors [A] into the toilet.
Thread the bolts [D] through hinges [C] and toilet.
Attach the nuts [E] and washers [B] to the other end of the bolts. Do not fully tighten the bolts.

Step 2:

Step 3:

FAQ

Q: How much weight can the toilet seat support?
A: The maximum weight capacity of the toilet seat is 150KG.
Q: How should I install the toilet seat?
A: Follow the provided installation steps in the user manual for proper installation. Make sure to align the holes and adjust the seat until it’s centered.
Q: Can I expose the toilet seat to direct sunlight?
A: It is not recommended to expose the toilet seat directly to sunlight for long periods. Also, avoid any direct strong light or high temperature.

INSTRUCTION MANUAL

Toilet Seat

support@storemic.com
supportjp@storemic.com (JP)

Note

Please read the instructions carefully to get to know the product. Follow the instructions to install the toilet seat correctly.
Please keep the instructions after reading. If you have any concerns or questions, please customer service at support@storemic.com .
Please do not open the toilet seat lid over 105° before you ﬁx the seat on the ceramic toilet bowl.

Cautions

To extend the lifespan of the soft-close toilet seat, do not slamming shut the seat.
Maximum load 150KG. Do not exceed the maximum weight capacity.
Do not expose the toilet seat directly to sunlight for long periods. Avoid any direct strong light or high temperature.

Tools Needed (Not Included)

Insert the expansion anchors [A] into the toilet. Thread the bolts [D] through hinges [C] and toilet, and then attach the nuts [E] and washers [B] to the other end of the bolts (DO NOT fully tighten the bolts).
Align the holes on the toilet seat to both hinges, and push the toilet seat into the hinges. Adjust the toilet seat until it’s centered.
Press the quick release button to remove the toilet seat from the hinges. Tighten the bolts [D] further while holding the nuts [E] underneath.
Add the hinge caps and reattach the toilet seat.

860-00065-01 Rev00