elk HOME 89731-2 Cecil Light 14 inch Matte Black Instruction Manual
- June 15, 2024
- elk HOME
Table of Contents
elk HOME 89731-2 Cecil Light 14-inch Matte Black
WARNING
DISCONNECT POWER AT THE MAIN FUSE BOX BEFORE INSTALLATION.
WARNING
This fixture is intended for installation by the National Electrical Code
(NEC) and all local code specifications. If you are not familiar with code
requirements, installation by a certified electrician is recommended. Before
assembly, remove all parts and part packages from the box. If anything is
missing, please contact the retailer from which the product was purchased.
Installation
-
Hold mounting bracket (A) so the two holes along the edge of the mounting bracket (A) are on the top and bottom of the mounting bracket (A) and the head of the attached ground screw is facing outward.
-
Carefully pull house wires through round holes in the mounting bracket (A). Align holes in the mounting bracket (A) with holes in the junction box.
-
Thread each junction box screw (B) into holes in the mounting bracket (A) and into holes in the junction box. Tighten junction box screws (B) to secure mounting bracket (A) to the junction box.
CAUTION:
Make sure house wires are pulled completely through the hole in the mounting bracket. DO NOT pinch wires between the mounting bracket and wall. -
Strip 3/4” of insulation from the ends of fixture wires. Slightly loosen the ground screw on the mounting bracket (A). Do not completely remove the ground screw. Wrap house ground wire (copper) around the ground screw, leaving enough ground wire to attach to the fixture ground wire. Twist the end of the fixture ground wire and the end of the house ground wire together.
-
Twist wire nut (C) onto the ends of the wires. Completely tighten wire nut (C). Reference the chart below for correct wire connections. Twist the end of the house lead wire (black) and end of the fixture lead wire together. Twist wire nut (C) onto ends of the wires. Completely tighten wire nut (C). Twist the end of the house neutral wire (white) and the end of the fixture neutral wire together. Twist wire nut (C) onto the ends of the wires. Completely tighten wire nut (C). Reference chart to the right for correct wire connections.
-
Wrap electrical tape (not included) around wire nuts (C) and wires. Ensure wires are securely fastened into wire nuts.
-
Carefully push all wires and wire nuts into the junction box.
-
Place backplate (D) over mounting bracket (A).
CAUTION: Do not pinch wires between the backplate and wall. -
Align holes in the top and bottom of the backplate (D) with holes in top and bottom along the edge of the mounting bracket (A). Thread one fixture mounting screw (E) into each hole in top and bottom of the backplate (D) and into holes in the mounting bracket (A). Tighten fixture mounting screws (E) to secure the fixture to wall.
-
Screw recommended bulb (E12 candelabra bulb type, not included) into the socket. Verify the correct bulb wattage marked on the socket of the fixture.
WARNING: DO NOT exceed the maximum bulb wattage.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>