belkin WLS0503 Wemo Smart Light Switch Home App User Guide
- June 15, 2024
- belkin
Table of Contents
belkin WLS0503 Wemo Smart Light Switch Home App User Guide
The Wemo Smart Light Switch 3-Way, WLS0503 supports both single-pole and 3-way configurations. Compatible with neutral wiring used in most homes, it helps eliminate guesswork and provides peace of mind in a smart lighting solution. The Wemo® WLS0503 is Thread-certified, built on the latest and greatest technology, and works exclusively with Apple® HomeKit®.
This article will help you set up the Wemo WLS0503 with the Apple Home app.
Before you begin:
You will need an iOS device supporting iOS 12 or higher that has the Apple Home app.
Connect the Wemo WLS0503 to your home wiring. Once done, turn the power back ON. The Wemo WLS0503 will boot up but not directly into setup mode.
Place the Wemo WLS0503 into setup mode. Press any button on the Wemo WLS0503
when the status light begins to flash white. The status light will begin
flashing blue to indicate it is now in setup mode.
Using NFC setup
If your iOS device supports Near Field Communication (NFC), you can use this for a quick and easy setup.
Step 1: Unlock your iOS device and hold it near the Wemo WLS0503. The NFC
transmitter is located in the center of the unit.
Depending on the iOS device used, you may need to move it up or down slowly to
an active NFC setup.
Step 2: Once detected, a setup prompt will appear. Tap Add to Home to add
to your Home app.
The Apple Home app will take over and continue the setup for you. Simply
follow any on-screen instructions. Once the Home app finishes the setup, you
can begin customizing and using your Wemo WLS0503.
Using HomeKit® code setup
If your iOS device does not support NFC, you can use the HomeKit setup code located in the quick start guide that came with your Wemo WLS0503. If you misplaced this code, you can also find it on the front of the Wemo WLS0503 behind the faceplate.
HomeKit Setup Code
Step 1: Open the Apple Home app and tap on the plus ( + ) sign located in
the upper right-hand corner of the app.
Step 2: Tap on Add Accessory.
Step 3: Locate the HomeKit setup code and scan it with your device’s
camera.
NOTE: The HomeKit code can be found on the quick start guide that came in the package with your Wemo WLS0503 or on the front located under the faceplate.
Step 4: Once detected, a setup prompt will appear. Tap on continue to add to your Home app.
The Apple Home app will take over and continue the setup for you. Simply follow any on-screen instructions. Once the Home app finishes the setup, you can begin customizing and using your Wemo WLS0503.
Was this support article useful?
Additional Support Questions?
Search Again
Charge faster. Network smarter. Save $15 on purchase over $80 with code: NOV22. Shop now
References
- Mobile & Computer Accessory Products | Belkin US
- Shopping Cart | Belkin US
- Login | Belkin US
- Live Chat, User Guides, FAQs & More | Belkin Support US
- Shop Wireless Chargers, Screen Protectors & More | Belkin US
- Where to Buy | Belkin US
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>