SCENTA AE103 Aroma Diffuser Owner’s Manual

SCENTA AE103 Aroma Diffuser

Specification

Bluetooth instruction

Where to get the app
Please search for “scent marketing” in Google Play or the App Store.

Note

1. Please make sure that the Bluetooth function is turned on
2. Please make sure that the location function of the mobile phone is turned on.

Amend password
If you forget the password, please press the reset button to restore the factory setting. The factory settings password is 8888.

Installation method

1. Unscrew the lower cover;
2. Unscrew the oil bottle to fill or change the essential oils;
3. Screw the oil bottle and the lower cover;
4. Plug in the sockets.

Application place

• Hotel
• Toilet- Aisle
• Meeting room
• Brand store

Operating instructions
APP version: Controlled by APP, more convenient and intelligent

Concentration and consumption

Notes

1. The working time above of each grade is 15s.
2. Different grades and oils may have different consumption.

Warning

1. Please keep the machine vertical. Tilt or lying flat may cause the oil to overflow. The efficiency of the machine may be affected.
2. Shall not modity, disassemble or repair the machine.
3. Do not use this product under high humidity and high-pressure conditions.
4. It is better to screw the machine on the wall than just stick it via tape; otherwise, the machine will be easy to fall.

Troubleshooting

Before asking to have the machine repaired, please try to diagnose the problem first by following to below instructions.

Equipment cleaning
The machine needs to be cleaned when the below situations happen:

1. You’re about to change to another kind of essential oil;
2. The atomization volume becomes weak.

Cleaning steps

1. Pull out the atomized head, and loose the bottle.
2. Find a larger container and fill the industrial alcohol up, then soak the bottle for 5-10mins.
3. Airing the bottle.

FCC Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, under part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

RF Exposure
This device complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body.

ISED Statement
This device contains licence-exempt transmitters)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device. The digital apparatus complies with Canadian CAN ICES – 3 (B)/NM B-3(B).

This device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS 102 RF exposure, users can obtain Canadian information on RF exposure and compliance. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>