ESR P1010176 Cyber Armor Tough Hülle Installation Guide
- June 15, 2024
- ESR
Table of Contents
ESR P1010176 Cyber Armor Tough Hülle
Installation Guide
-
Attach hinge stickers (A and B) to the back of the iPad, spaced out near the edge of one of the long sides.
-
Put the iPad on a flat surface and lay a screen protector on the screen, with the black side of the film sticker down
-
Fold over hinge stickers and attach them to the screen protector.
-
Attach lifting sticker (C) to the opposite side of the screen protector and then use it to fold back the screen protector.
-
Use the included cleaning kit to clean the iPad screen thoroughly.
-
Use a film sticker to remove the film from the screen protector.
-
Fold the screen protector onto the screen.
-
Swipe fingers across the screen protector to fully apply and then remove all stickers.
-
In case of bubbles, lift up the nearest edge of the screen protector and then reattach.
-
Remove the edge cover from the back case.
-
Put iPad into back case.
-
Align the edge cover with the back case and push down firmly to attach. The pen slot on the side of the case is compatible with Apple Pencil and the ESR Digital Pencil.
-
Using Your Case Stand
Rotate the stand ring so the flat edge is facing the long side of the iPad for landscape view/short side of the iPad for portrait view > Pull out the stand ring and position on a flat surface. -
Hand strap: Insert hand into strap on the back of case > Adjust the size of strap to fit hand > Rotate ring for holding in landscape or portrait.
-
Carry strap: Hook both ends of the carry strap onto hoops on the sides of the back case > Carry on shoulder or hang on an object (e.g. back of car seat)
-
Avoid pulling the hand strap and carry the strap forcefully. Doing so may cause damage.
-
This case is fully compatible with all ESR screen protectors, which can be purchased on the ESR Amazon Store or Official Website (www.esrgear.com
Scan to watch a quick setup video
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>