CYOEST CAR21 Remote Control Car Installation Guide
- June 15, 2024
- CYOEST
Table of Contents
FCC ID: 2A5C9-CAR21
Model: CAR21
If you have any questions or need help, you can click “seller contact” button in your Amazon account to contact us. We will solve it within 24 hours
Remote Control Car
step1:Install remote control panel using 6mm[long] screw. 
step2:Install the antenna and
the white wire usinga 4mm[short] screw. 
step3:Install the 3 small boards and two caps.
step4:Install the battery box. Secure with adhesive tape.
step5:connect wires by picture. (need to be fully
inserted)
step6:Install by picture. The remote control is
assembled.
step7:Assemble the motor with two supporting parts
step8:The shaft of the motor
fits perfectly into thepinion. 
step9:This step must be firmly installed or the motor
operation will be affected. 
step10:Connect the motor to the [ B & F ] terminal of
the remote control board,The end of the motor wire should be fully inserted
into the remote control board. 
step11:Install the battery box with two 4 mm
screws.The wire through the square hole. 
step12:Connect the wire between the battery
box and the remote control panel [ B+ B- ] Install remote control panel with
adhesive tape 
step13:Install by picture 
step14:Install 4pcs 6mm
screws.
step15:Install by picture. 
step16：Install an orange kit and a white
pulley.
step17：Install a wheel. 
step18:Install a front wheel and two orange
kits. 
step19:Install a white pulley.
step20:Install the other front wheel. 
21:Install rubber band.Make
sure the rubber band is attached to both pulleys. 
step22：Install two cover
plates.
step23：Install 4 batteries.Please note that the antenna should
not be held during remote control. 
If you have any questions or need help, you can
click “seller contact” button in your Amazon account to contact us. We will
solve it within 24 hours!
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-
Consult the dealer or an experienced radio/TV technician for help.
-
RF warning for Portable device:
The device has been evaluated to meet general RF exposure requirement. The device can be
used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>