regalo 1345 192 Inch Double Door Super Wide Adjustable Baby Gate Instruction Manual
- June 15, 2024
- regalo
Table of Contents
2 in 1 Super Wide” Safety Gate and Play Yard
Models : 1345
1345 192 Inch Double Door Super Wide Adjustable Baby Gate
« READ ALL INSTRUCTIONS BEFORE ASSEMBLY AND USE OF GATE.
KEEP INSTRUCTIONS FOR FUTURE USE.
www.regalo-baby.com
Regalo International, LLC.
3200 Corporate Center Drive, Suite 100
**** 866.272.5274 (U.S. only
0 952.435.1080
Made in Vietnam
Before Assembly
PLEASE CHECK TO
MAKE SURE YOU HAVE THE FOLLOWING PARTS:
A Play Yard Gate Frame (6 Panels)
B Plastic Mounting Brackets (4 – Attached to Gate Frame)
C 1 Wall Mount Screwis (8) (requires Philps/cross-head screwdriver)
BEFORE USING PRODUCT
Read and follow all instructions carefully to ensure that your gate and
extensions are properly installed. Improper installation could result n the
gate becoming unstable or dislodged from the doorway. Always make sure the
extension is securely attached to the gate before using. The safety of your
child is your responsibilty. Please keep these instructions for your
reference.
IMPORTANT
- The four mounting brackets must be used in securing the gals To the wall. Thess braket provent gate from dislodging from its opening and becoming unstable.
- If hardware mounting to a surface other than drywall or wood, please consult vith a professional about installation.
- The maximum width of this gate is 194 inches.
90 DAYS LIMITED WARRANTY
If during the first 90 days after consumer purchase of the item, under reasonable and non-commercial use and conditions of maintenance, it fails while owned by the original purchaser because of the quality of materials or workman- ship of finish and assembly, Regalo International, LLC, will feplace or replr it Raglos option. PROOF OF PURGHASE REQUIRED.
CARE AND MAINTENANCE
Peridial check the gt fr s of damage,vear, or missing components.
Do not use if any part is missing, worn or damaged. Check the gate reqularly
to ensure ai the hardware and mountings are fightened. Do not use abrasive
cleaners or bleach. Clean by sponging with warm water and amild detergent.
Option A: Installing Your Gate Between Two Walls 
Loosen the hinge knob in the clockise
direction. Daing ths villt allow the gate to unfold.
Use a
Phillips/crosshead screwdriver (C) to fix the wall mounting bracket (B) o the
vall Repeat fo al four brackes. 
Arrange the panels to your desired
configuration, then tighten allof the hinge knobs.
NOTE: This gate i designed to it openings 51,5 nches (130,81 cm) o 194
nches (492.75).
Option B: Installing Your Gate as a Play Yard 
Tuistthe hinge knobs in clockwise
direction to loosen. 
Removing the Wall Mount: Panel 1
Loosen the hinge knob in the clockvise direction to disengage the locking
teeth. Siide the hinge knb and the toothed hinge cover cap downward. Pull the
tube along with the hinge knab, toothed hinge cover cap, and wal mounts away
from the gate 1o release ai the parts. Remove the male hinge cover cap from
the bottom. Removing
the Wall Mount: Panel 2
Loosen the hinge knob in the clockvise direction to disengage the locking teeth. Siide the hinge knob and the tootned hinge cap downward. Pull the tube along with the hinge knob, toothed hinge cap, and wall ‘mounts away from the gate to release all the parts. Remove the female hinge cover cap from the bottom.
Position the
play yard into your desired configuration (6. octagon, square), then Join the
ree ends o the play yard together at the plastic jonts
Place the tube with the hinge knob on it
into the Tole i the bottom of the extension ate. Stand tube vertically and
connect hinge knob 1o top.
Side the tube into place and screw the
hinge knob in the counter clockwise direction to tighten. 
Assembly is now
complete.
NOTE: When adding orremoving ‘additional panel units to the configuration, panels must be added or subtracted in sets of two for the freestanding enclosure to function propery.
Gate Operation
To open the gate,
start with rotating the base lock in the upward direction. Do this on both
sides of the door.
NOTE: You can rotate the base lock in either direction.
Press the release
button down on the handle Slide the handle back towards the hinge.
NOTE: When closing the gate you must do the same operation
WARNING
- Install according to manufacturer’s instructions.
- To prevent serious injury or death, securely install gate or enclosure and use according to manufacturer’s instructions.
- Children have died or been seriously injured when gates are not securely installed. Always install and use as directed using all required parts.
- Never stack gates on top of each other to form a taller barrier. This could result in serious injury or death.
- Stop using when a child can climb over or dislodge the gate.
- Use only with the locking mechanism securely engaged.
- To prevent falls, never use at top of stairs.
- Never use to keep child away from pool.
- Intended for use with children from 6 months through 24 months.
- Always ensure the gate is resting against the floor before beginning installation.
- This product will not necessarily prevent all accidents. Never leave child unattended.
- Check the gate regularly to see if all the hardware and mountings are tightened.
- Do not use if any component is missing or damaged.
- Adult assembly required.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>