FOSHAN 2BDSZ-BLACK Remote Control Instructions
- June 15, 2024
- Foshan
Table of Contents
the technical parameters
According to the keypad/remote control instructions
-
Press the key pad instructions (decorating furnace core/heater core)
ON OFF → indicates whether the power is turned on
Dimming button → indicates automate adjustment of flame brightness
The low → key indicates that the flame is weakened manually
The high → key indicates that the flame is manually enhanced -
Remote contelo operating instructions
Maintenance
- Before the product is cleaned. the power must be cut off.
- Prohibition of direct water washing the fuselage.
- Do nor use any abrasive tools or solvers that can damage the surface.
- Prohibited to open the product for transformation. the proposed regular inspection of the product and clean with a dry cloth to extend its service life.
Troubleshooting
- Arter the power is inserted. the hose will emit a “drop” sound as a reference for power-on.
- The flame light and then go out. check the box is wet, ventilated and and dried. and restart the power.
- Heater suddenly does not work, is due to heating and time is too long. turn off the power 20 minutes after the restart
Note: Due to product hardware and software upgrades from time to time. such as instructions and products differ. please prevail to the existing product If the above self test method can not solve or have any other questions please contact our online customer service, we will give you a satisfactory reply.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 1S of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- In crease the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction