DieseRC 2204 Universal Wireless Remote Control Instruction Manual
- June 15, 2024
- DieseRC
Table of Contents
**DieseRC 2204 Universal Wireless Remote Control Instruction Manual
**
PRODUCT INFORMATION PRODUCT DETAIL WIRING DIAGRAM
TYPE—-2204
Technical Data
Working voltage| AC 85V~250V
Input/output vlotage| 1~250V
Output Type| Passive output
Quiescent Current| <5MA
Max current| 10A
RF frequency| 433MHz
Working temperature| -30~+80
Receiving Sensitivity| >97dbm
Amount of storage remote controls| 20 pieces
Support encoding| 1527 Leaning code、2262 fixed code
RF Ovperating mode| ASK superheterodyne wireless reception
Receiving range| Open space is more than 50 meters
Remote operating mode| Momentary Mode /Toggle Mode /Latched Mode
PRODUCT DETAIL
NO: Normally open pin
COM: Common pin
NC : Normally closed pin
WIRING DIAGRAM
WIRING DIAGRAM
Warning
- Usually the receiver and transmitter have been paired with each other in factory. If not,please reprogram them.
- Reset before you want to change the operating mode.
- After reset, all the remote controls cannot work anymore.
- Replace the battery in time when the remote transmitter voltage is low. To get the stronger signal transmission.
- Slightly stretch the antenna on the receiver for better signal reception.
- The remote transmitter need to have 5 or more buttons, if you want to set up in latched mode.
- The output type is passive output / potential-free contacts.
Operating Mode
Momentary Mode:
- Press and hold on button “A”, relay “1” will turn on;
- Release the button “A”, this relay “1” will turn off.
How to program
- Press the learning button (on the receiver) 1 time. The indicator LED on the receiver will light up;
- Press button “A” on the remote transmitter. The indicator LED on the receiver will flashing several times and then light down. Succeed.
Toggle Mode:
- Press button “A”, relay “1” will turn on;
- Press button “A” again, this relay “1” will turn off.
How to program
- Press the learning button (on the receiver) 2 times. The indicator LED on the receiver will light up;
- Press button “A” on the remote transmitter. The indicator LED on the receiver will flashing several times and then light down. Succeed.
Latched mode:
- Press button “A”, relay “1” will turn on;
- Press button “B”, relay “2” will turn on, at the same time relay “1” will turn off.
How to program
- Press the learning button (on the receiver) 3 times. The indicator LED on the receiver will light up;
- Press button “A” on the remote transmitter. The indicator LED on the receiver will flashing several times and then light down. Succeed.
Reset Press the learning button (on the receiver) 8 times. The indicator LED on the receiver will flashing several times and then light down. succeed.
Troubleshooting
If the receiver and transmitter cannot operate normally, try to solve the
problem by follow the
step below.
- Please check if batteries power is used up. The indicator LED on remote transmitter does not light up or is dimly lit.
- Please check if your receiver is wired correctly. It is important to make sure the wiring is correct.
- Reprogram the receiver and transmitter. Usually this can solve a lot of problem.
- If the problem still remains, please contact us in time. We will do our best to solve your problem.
Email: “dieseelectronic@163.com” or
WhatsApp: +86 13502278583
If there is any questions about the products,please contact us firstly. We will do our best to solveyour problem. Thank you.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>