DieseRC 1204 12V Remote Control Switch Instruction Manual
- June 15, 2024
- DieseRC
Table of Contents
DieseRC 1204 12V Remote Control Switch
PRODUCT INFORMATION
TYPE—-1204
Technical Data
PRODUCT DETAIL
WIRING DIAGRAM
Warning
- Usually, the receiver and transmitter have been paired with each other in the factory. If not, please reprogram them.
- Reset before you want to change the operating mode.
- After resetting, all the remote controls cannot work anymore.
- Replace the battery in time when the remote transmitter voltage is low. To get a stronger signal transmission.
- Slightly stretch the antenna on the receiver for better signal reception.
- The remote transmitter needs to have 5 or more buttons, if you want to set up in latched mode.
- The output type is passive output / potential-free contacts.
Operating Mode
Momentary Mode:
- Press and hold on button “A”, relay “1” will turn on;
- Release the button “A”, this relay “1” will turn off.
How to program
- Press the learning button (on the receiver) 1 time. The indicator LED on the receiver will light up;
- Press button “A” on the remote transmitter. The indicator LED on the receiver will flash several times and then light down. Succeed.
Toggle Mode :
- Press button “A”, relay “1” will turn on;
- Press button “A” again, this relay “1” will turn off.
How to program
- Press the learning button (on the receiver) 2 times. The indicator LED on the receiver will light up;
- Press button “A” on the remote transmitter. The indicator LED on the receiver will flash several times and then light down. Succeed.
Latched mode:
- Press button “A”, relay “1” will turn on;
- Press button “B”, relay “2” will turn on, at the same time relay “1” will turn off.
How to program
- Press the learning button (on the receiver) 3 times. The indicator LED on the receiver will light up;
- Press button “A” on the remote transmitter. The indicator LED on the receiver will be flashing several times and then light down. Succeed.
Reset
Press the learning button (on the receiver) 8 times. The indicator LED on the
receiver will flash several times and then light down. succeed.
Troubleshooting
If the receiver and transmitter cannot operate normally, try to solve the problem by following the steps below.
- Please check if the battery’s power is used up. The indicator LED on the remote transmitter does not light up or is dimly lit.
- Please check if your receiver is wired correctly. It is important to make sure the wiring is correct.
- Reprogram the receiver and transmitter. Usually, this can solve a lot of problems.
- If the problem still remains, please contact us in time. We will do our best to solve your problem.
Email: “dieseelectronic@163.com” or
WhatsApp: +86 13502278583
CUSTOMER SERVICE
- Work volts : DC 12V
- Max current: 10Amp
If there is any questions about the products, please contact us first. We will do our best to solve your problem. Thank you.
Huizhou Wenqiao Electronic Technology Co., Ltd.
- Address: 1203, Building T19, Fangzhilonghuwan, Sanhuan South Road, Huicheng District, Huizhou City, Guangdong Province, China 516000
- WhatsApp: +86 13502278583 / +86 18138805271
- Email: dieseelectronic@163.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>