HandStands 2BDH4-15290 Wireless Charging Pad Instruction Manual

June 15, 2024
HandStands

HandStands 2BDH4-15290 Wireless Charging Pad

HandStands-2BDH4-15290-Wireless-Charging-Pad-product

Tech Specification

  • Input: 9V-2A/12V -2A
  • Output: 15W
  • Input Port: USB-C
  • Wireless Charger compatible with most QL-enabled devices

Product Overview

HandStands-2BDH4-15290-Wireless-Charging-Pad-fig-
\(1\)

  1. USB-C Port
  2. LED Indicators
  3. Wireless Charging Surface
  4. Desk Mat

Set up the wireless charging pad

Magnetically snap both the charging pad and the desk mat together. The charging pad will magnetically snap to the edge of the desk mat with the black fabric strip.

Wireless charging of a device

  1. Connect the included USB-C cable to the USB-C port and connect the other end to a suitable power source.
  2. Place your wireless charging-enabled device on top of the circular icon ( ) on the wireless charger. Look for the charging icon on your phone to confirm a successful charging connection.

LED Status

  • Solid Blue and Red ………………………. Initial Power On
  • Solid Blue ………………………. Wireless charging in operation
  • Solid Red ………………………. Metal or abnormal objects detected
  • Off ………………………. Power Off

Safety Information

  • Do not attempt to disassemble the product. It may result in short-circuit or damage
  • The product should be kept in a dry and ventilated environment. Do not store it in areas with high humidity or temperature Keep out of reach of children
FCC STATEMENT

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference, and
  2. This device must accept any interference received, including interference that may cause undesired operation.

FCC Caution:
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, under part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used under the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and the receiver.
  • Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement
The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co- located for operating in conjunction with any other antenna or transmitter.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals