Marsail TZESD6 Standing Desk Adjustable Height Instruction Manual
- June 15, 2024
- MARSAIL
Table of Contents
Marsail TZESD6 Standing Desk Adjustable Height
Specifications
Height Adjustment Range: 27.9″ – 46.8″ (71 cm-119cm)
Tools Needed (not included
Supplied Parts and Hardware for Step 1
Supplied Parts and Hardware for Step 2
NOTE: An extra wood dowel pin is provided for the longer 55″ / 63″ desk.
Supplied Parts and Hardware for Step 3
Supplied Parts and Hardware for Step 4
Supplied Parts and Hardware for Step 5
Step 1 : Assembling the Frame
Attach the motor.
Secure the motor.
Attach the right desk leg to the crossbar.
Attach the left desk leg.
Attach the side plates.
Slide the rod coupler onto the end of the motor drive shaft on the right leg.
Adjust uneven desk legs:
Before attaching the transmission rod, legs to see if they are set at the same
level. If not, insert the transmission rod into the hole in the left leg.
Turn the rod, using the wrench, to adjust the left leg so it’s level with the
right leg. Turn the rod clockwise to raise the left leg or anti-clockwise to
lower it.
Ensure the transmission rod is properly inserted into the hole inthe left leg. Slide the rod coupler to the left to connect with the other end of the transmission rod.
NOTE: If the transmission rod doesn’t flt smoothlyinto the hole of rod coupler, fine-tune flt with the wrench .
Use the set screws to secure the rod coupler.
Ensure the rubber pads are attached to the frame. If any have fallen off, reattach them or use the spare rubber pads.
Step 2: Assembling the Desktop
NOTE: There are pre-drilled holes on the desktop panels to use as guides for
screw installation. If you have any questions or issues, please call technical
support or email customer service.
For the 40″ / 48″ long desk, use the five wood dowel pins to join the two
desktop panels together.
For the 55″ / 63″ long desk, use the six wood dowel pins to join the two desktop panels together.
Secure the desktop panels with the connectors, then attach the cable management bracket to the desktop.
Step 3: Attaching the Desktop
Attach the frame to the desktop.
Attach the storage hook and controller to the desktop.
Step 4: Connecting the Cables
NOTE: An example of a cable clip layout is indicated below. However, the
cable clips can be arranged according to your needs.
Step 5: Attaching the Side Pocket
Thread the bolts through the holes in the side pocket and the side plate from
the outside.
Using the Controller
Note: Ensure that there are no obstacles when using the desk, that the
desktop is not right next to the wall, and that all cables are long enough for
the desk to move up and down freely. When the controller screen is off (power-
saving mode), press any button to wake it before operating the desk.
Suggestion: Set the most comfortable height when you sit down to [I] and
the most comfortable height when you stand up to [g] . The other two presets
can be set for another user or to other heights you want to use.
Settings
Troubleshooting
- lease try resetting the desk if you have any issues like the following:
- Abnormal operation.
- The controller screen displays ‘RST’ (reset).
- The controller screen displays error message E01 -E08, but the motor cable is connected correctly.
- If the controller screen displays ‘HOT,’ please wait 20 minutes for the motor to cool down before making any further height adjustment.
All of us do appreciate your product purchase. We hope that you are as happy with your product as we are designing and manufacturing it for you. We strive to provide you with the best quality products and services in the industry. Should you have any issues, please don’t hesitate to contact us.