Marsail TZEDS2 Adjustable Height Electric Standing Desk Instruction Manual
- June 14, 2024
- MARSAIL
Table of Contents
Marsail TZEDS2 Adjustable Height Electric Standing Desk
Thank you for choosing this product! We strive to provide you with the best quality products and services in the industry. Should you have any issues, please don’t hesitate to contact us
Technical Support:
877-546-8648 Mon-Fri 8am – 8pm(CST)
Other Info: support@ciays.com
Model : TZEDS2/TZEDS2B1/TZEDS2N
Specification
Supplied Parts
ASSEMBLING
-
Assemble the Leg Bases and Crossbar
-
Secure the Side Plates and Transmission Rod to the Table Legs
-
Loosen the pre-assembled coupling nut to adjust the length
-
Insert the transmission rod on the left leg into the hex hole and turn the transmission rod anti-clockwise until the left leg goes to the lowest position.
-
Insert the other end of the transmission rod to the slot on the right leg (You may rotate the rod slightly for better installation).
-
Secure the transmission rod to the slot by tightening the pre-assembled set screw clockwise using the small Allen key [G].
How to Solve the Problem of Different Heights of Two Table Legs -
Step 1. Measure whether the height of the two table legs are the same using a measuring tape before installation
Install Transmission Rod: Please fine-tune the transmission rod -
Step 2. If the height of left table leg is higher than the right table leg, insert the transmission rod into the hexagonal hole of the left leg, then rotate the transmission rod anti-clockwise to fine-tune the left leg to make the left table leg as high as the right table leg.
-
Secure the Desktop to the Stand
-
Connect the Cables
-
Place the Monitor Stand on the Desktop
CONTROLLER INTRODUCTION
Protection Mode (auto lock screen mode)
Protection Mode (auto lock screen mode)
Over-heating protection| Hot: It alarms when continuously working for 2 minutes. Re-powered on and waiting for at least 18 minutes before
height adjustment.
Sensorless alarm| E10: It alarms when motor sensor can’t be detected.
Power off first. Check the connecting of motor and control box, and then re- power on.
Overload protection| E20: Overload alarm. If alarming when desk going up,
remove the stuff on the desk and try again. If alarming when desk going down,
power off first, remove the stuff on the desk and re-power on.
Rebound protection| E02: It alarms when vibrated, collided or inclined in desk
moving. Check if there is vibrating, obstacles or incline. If no issues above,
do the reset process and use it again.
Overvoltage alarm| E32: It alarms when voltage is higher than required value.
Power off first. Check whether the connection between power and control box is OK. Power on again.
Undervoltage alarm
| E31: It alarms when voltage is lower than required value.
Power off first. Check whether the connection between power and control box is OK. Power on again.
Step out alarm
| E60: It alarms when height difference between left leg and right leg exceeds the set value.Power off first. Check whether the left leg and the right leg are in the same height. If not, re-redo
process 4 to make them in same height. Power on again.
Breaking protection| It stops and enters protection state when motor lines or manual control lines are removed or disconnected accidentally;
back to normal after reconnected and alarm cleared.
Thank you again for choosing this product!
All of us do appreciate your product purchase. We hope that you are as happy
with your product as we are designing and manufacturing it for you. We strive
to provide you with the best quality products and services in the industry.
Should you have any issues, please don’t hesitate to contact us
Technical Support:
877-546-8648 Mon-Fri 8am – 8pm(CST)
Other Info: support@ciays.com
860-00047-00 Rev00
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>