Karibu 33734 Garden Houses Saunas Instruction Manual
- June 15, 2024
- Karibu
Table of Contents
Karibu 33734 Garden Houses Saunas
Product Information
Specifications
- Product Name: Karibu Holztechnik GmbH
- Address: Eduard-Suling-Str. 17, 28217 Bremen
- Email: info@karibu.de
Product Usage Instructions
Step 1: Determine and See Length
The length of the product must be determined and sawn according to your
needs.
Step 2: Check for Accessories
Make sure to check if all the necessary accessories are included in the
package.
Step 3: Temporary Fixing
Temporarily fix the product in place before final installation.
Step 4: Inventory of the House
Take inventory of the house to ensure all the required materials are
available.
Step 5: Tools
Make sure you have the following tools:
Step 6: Compare Material List with Package Contents
Before starting the installation, compare the list of materials with the
contents of your package. Any complaints can only be processed if the parts
have not been assembled yet.
Frequently Asked Questions (FAQ)
-
Q: What tools do I need for installation?
A: You will need the following tools: X, X, X, X, X, X, X. -
Q: Can I start the installation before comparing the material list with the package contents?
A: It is recommended to compare the material list with the package contents before starting the installation. Any complaints can only be processed if the parts have not been assembled yet.
Not included
- Length must be determined and sawn
- Not needed
- with accessories!
- Fixed temporarily
- Inventory of the house
Tools
First compare the list of materials with your package contents! Please understand that complaints can be processed in the non-built status only!
Overview
Length must be determined and sawn
Mounting roof
Not included
Roofing felt installation
Note! This description is only an example!
The number of bitumen strips to be used depends on your actual house size.
When joining rolls of roofing felt end to end, the overlap must be
approximately 10cm. The roof is not safe to walk on. The roof is designed for
a total load (snow, wind) and not for a point load. We recommend you to always
support the roof from below during installation. The sealing of the roof
surfaces to adjacent components with bitumen sealant has to be effected by the
customer! If it is a saddle-roofed house, do not use roofing tiles for
roofing. In this case, a 20 cm wide strip of bitumen with an overhang should
be installed on both sides of the eaves. For houses with a tonne roof, please
install a bitumen roofi ng under the shingles. In the case of a fl at roof
the laying of roof shingles is not possible!
Not included! Protect from moisture!
Karibu Holztechnik GmbH ● Eduard-Suling-Str. 17 ● 28217 Bremen
info@karibu.de