winees WP01002 2K Indoor Security Camera Instruction Manual

Table of Contents

winees-WP01002-2K-Indoor0-Security-product

CAUTIONS

To avoid personal injury and/or possible product damage, the following cautions must be followed,

Please use sorely the provided adapter instead of others in case of any damage to the product.
Keep out of reach of children. This product contains small magnets and other small parts, which can cause choking or injury if ingested.
To prevent early failure .the camera should only be installed in operating environments ranging between -10°C-40°C{14° F- 1040 F).
Do not install
- in wet locations
- outside the premises (outdoors)
- close to heat source
- near the metal objects and mirrors that cause radio signal attenuation or shading.
Do not disassemble or reinstall the camera, otherwise it may cause security risks.
Unplug the power cord before cleaning. Do not clean it with any liquids, spray cleaner or wet cloth.
The slot and opening are used for ventilation, not allowed to be blocked or covered.

This device complies with Part 15 of the FCC Rules. Operation 1s subject to the following two conditions,

This device may not cause harmful interference.
This device must Accept Any interference received, including interference that may cause undesired operation.

Note , Tl;e grantee 1s not responsible for Any cl;Anges or mod1f1cAt1ons not expressly approved by the party responsible for compl1AncA. Such modif1cAtions could void thA usAr’s Authority to operate the equipment.
NOTE This equipment has been tasted and found to comply with the l1m1ts for A CIAss fl clig1tAI device, pursuant to pArt 15 or the FCC Rules. These l1m1ts are designed to provide reasonable protection A!JAinst harmful interference 1n a resident 1al installation.
This oqu1pmont gonoratosusos and can rad1ato radio frequency energy and, 1f not 11;stalled and used in accordance with the 1nstruct1ons, may cause harmful 1ntorforonco to radio commun1cat ions. However. there 1s no guarantee taut interference will not occur 1n a particular 1nstallat1on.
If this oqu1pmont duos causal harmful interference to radio or telev1s1on reception, which can be dotorm1nod by turning the oqu1pmont off and on. the usury 1s encourages lo try to correct the interference limy one or more of the following measures.
Reorient or relocate the rece1v1ng antenna.
lncroaso the separation baton the oqurpmont and roco1vor.
Connect the equipment into an outlet on a circuit different from that to which the roco1vor 1s connected.
Consult the dealer or an experienced rad10/lV tecl;r11c1an for help

This equipment complies will; FCC radiation exposure l1mlls set forth for an uncontrol Lod onv1ronmont. This oqurpmont should installed and operated with minimum distance of ?O cm lie tween the radiator and your body

winees-WP01002-2K-Indoor0-Security-Camera

Method 1: Table stand
Method 2
Mount on masonry surface I wooden surface I metal surface, or paste on clean surface
Step 1: Separate the magnate mount.
Step 2, Choose different installation accessories according to different surfaces

If the default adding camera operation fails

U- Make sure your wireless router has the Internet access, and the Wi-Fi signal at the location where you install the camera is good.
Make sure the camera is plugged in and the status LED is on or flashing
Reset the camera if the LED is NOT flashing green. Then follow the App to add it.
Make sure the camera is not added to other user’s account. If it is, the owner of the camera has to unbind it first.
When this step is done, the camera should be added to your account. If the Micro SD card is not detected by the camera
Make sure the card is good and format it again in the FAT-32 format. How to do the forced reset?
If you cannot reset the camera from the setting page, please hold the reset button in the pin hole with the reset pin for 5 seconds and release. The camera will play a voice prompt” Restoring factory settings”. The time of the camera video stamp is not right
Please set the right time zone in the settings. How long can a Micro SD card (not included) of different capacity record?

winees-WP01002-2K-Indoor0-Security-07

Requirements and Tech Specs

Wi-Fi Network Requirements in order to connect your camera to your Wi-Fi network, it will need to meet the following requirements.
Supports IEEE 802.11b/g/n
Your Wi-Fi network broadcasts at 2.4GHz. 5GHz band is not supported
Your network upload speed is suggested to be greater than 1 Mbps to have fluent video streaming.
Power (Only for CE) 100 ~ 240VAC 50/60Hz power supply for the AC adapter DC 5V/1A Micro USB input for the camera
Maximum power consumption: 5W Frequency range: 2412-2472MHz Maximum RF transmit power: 802.11b 16+2dBm, 802.11g 54M 14+2dBm, 802.11n HT20 12=2dBm, 802.11n
HT40 12+20Bm Minimum radio-frequency knower. 16 aRm]

Camera

Storage

Step
Scan the QR code below, or search for”AiDot” in App Store or Google Play.
Step2
Create an account and sign in.
Step3
Press’+’ button to add the Winees Cam mini.
Step 4
Follow the instructions on App. For more information about usage guidelines and FAQs ,please visit https://www.iwinees.com

Correct Disposal of this product.

This marking indicates that this product should not be disposed of with other household wastes throughout the EU.
prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources.
To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmentally safe recycling.
Means for applicable power supplies see user instructions Adapter model(s): DSA-5PF07-05 FEU 050100, DSA-5PF07-05 FUK 050100, Made By: Dee Van Enterprise Co., Ltd.

Declaration of Conformity

Hereby, Linkzone, declares that the radio equipment product name (WP01002) is in compliance with Directive 2014/53/EU. The full text of the EU Declarations of Conformity are available at the following internet address: www.iwiness.com
Linkzone Technology Co., Limited ROOM 20 5/F WAYSON COMMERCIAL BLDG 28 CONNAUGHT ROAD WEST SHEUNG WAN HK Phone: 1-855-334-9800(24×7) www.iwinees.com support@iwinees.com MADE IN CHINA