HALCYON 13W Exterior Surface Mount Spot Instruction Manual
- June 10, 2024
- HALCYON
Table of Contents
HALCYON 13W Exterior Surface Mount Spot
Product Information
The EX801 Luminaire is a lighting fixture that comes with a non-replaceable light source. The luminaire has an external flexible cable or cord that, in case of damage, must be replaced only by the manufacturer, their service agent or a qualified person to prevent any hazards. The product is designed to work on concrete or wood board surfaces with a minimum thickness of 5mm. The luminaire has an ON/OFF switch and requires a suitable tool to fix the back stand.
Caution:
- There is a risk of electric shock when operating the luminaire.
- Please read the instructions carefully before use.
Product Usage Instructions
- Before installation, make sure the wood board has a minimum thickness of 5mm.
- Choose a suitable tool to fix the back stand. Use Tool 1 to fix the back stand to the wood board or concrete surface.
- If you need to adjust the position of the fixture, please loosen the screw before making adjustments. Once you have adjusted it to a suitable position, fasten the screw again.
- After screwing the backplate to the wall, cover the screw heads with silicon sealer.
- Please note that the light source is non-replaceable. When it reaches its end of life, replace the entire luminaire.
- If there is any damage to the external flexible cable or cord, do not try to repair it yourself. Contact the manufacturer, their service agent, or a qualified person to replace it.
If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufacturer or his service agent or a similar qualified person in order to avoid a hazard. The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced.
This luminaire must be installed by a qualified Registered Electrician to prevent damage to the luminaire and maintain electrical safety.”
All exterior luminaires (with the exception of copper) require periodic cleaning to protect the surface and/or coating from corrosion and ensure a tidy appearance for the lifespan of the product. Wash with care using a soft brush and warm soapy water using a neutral detergent. Coastal areas require extra attention, especially fittings that are under eaves/soffits and do not have any exposure to rain. Do not use a water blaster or high-pressure hose, and do not submerge fittings for extended periods of time. 316 stainless steel fittings will still develop surface rust or “tea staining” if left uncared for.”
Caution, risk of electric shock.
Installations
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>