PHILIPS MG1100 16 Beard Trimmmer Instruction Manual

: June 15, 2024
: Philips

Table of Contents

Introduction
Important
General description (Fig. 2)
Preparing for use
Using the appliance
Trimming with the precision trimming head
Cleaning
Ordering accessories
Environment
Guarantee and support
Troubleshooting
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

**PHILIPS MG1100 16 Beard Trimmmer Instruction Manual

**

Introduction

Congratulations on your purchase and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome.

Important

Read this user manual carefully before you use the appliance and save it for future reference.

Warning

This appliance is not intended for use by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.

Caution

Always check the appliance before you use it. Do not use the appliance if any of its parts is damaged or broken, as this may cause injury.
Only use this appliance for its intended purpose as shown in the user manual.
If the appliance is subjected to a major change in temperature, pressure or humidity, let the appliance acclimatise for 30 minutes before you use it.
For hygienic reasons, the appliance should only be used by one person.
Be careful with hot water when you clean the attachments. Always check if the water is not too hot, to prevent your hands from getting burnt.
Never use compressed air, scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone to clean the appliance.
Only operate the appliance on one non-rechargeable 1.5V R6 AA battery.
Use and store the appliance at a temperature between 15°C and 35°C.
Do not expose the appliance to direct sunlight.
Remove the battery from the appliance if you are not going to use it for some time.
Maximum noise level: Lc= 75 dB(A).

Compliance with standards

This Philips appliance complies with all applicable standards and regulations regarding exposure to electromagnetic fields.
This appliance complies with the internationally approved IEC safety regulations and can be safely cleaned under the tap.

General description (Fig. 2)

Precision trimming head
Handle
On/off slide
Locking indicator
Locked’ indication
Unlocked’ indication
Battery compartment cover
Precision shaving head
Long trimming comb (L)
Medium trimming comb (M)
Short trimming comb (S)
Cleaning brush
Disposable AA alkaline battery

Preparing for use

Placing the batteries

To remove the battery compartment cover, turn it clockwise until the locking indicator points to the ‘unlocked’ indication.
Pull the battery compartment cover off the handle.
Put the battery in the battery compartment.

Make sure the + and – poles of the battery point in the right direction.
Note: The appliance runs on one R6 AA 1.5-volt battery (included). Preferably use Philips alkaline batteries. A new AA alkaline battery has an operating time of up to 2 hours.

Slide the battery compartment cover back onto the handle.
Turn the battery compartment cover anticlockwise until the locking indicator points to the ‘locked’ indication.

To avoid damage due to battery leakage:

do not expose the appliance to direct sunlight.
do not expose the appliance to temperatures higher than 35°C.
remove the battery if you are not going to use the appliance for a month or more.
do not leave an empty battery in the appliance.

Attaching and detaching attachments

Note: The precision trimming head and precision shaving head can be attached and detached in the same way.

To attach one of the attachments, align the locking indicator with the ‘unlocked’ indication and put the attachment on the handle.

Then turn the attachment clockwise until the locking indicator points to the ‘locked’ indication (I).

To detach the attachment turn it anticlockwise until the locking indicator points to the ‘unlocked’ indication. Then pull the attachment off the handle.

Using the appliance

When you trim your beard for the first time, be careful and test the appliance on a small part of your arm or leg. Do not move the trimmer too fast. Make smooth and gentle movements.
If any irritation or allergic reaction occurs, discontinue use immediately.
Do no use the appliance on sensitive or irritated skin.

Trimming with the precision trimming head

With the precision trimming head without trimming comb, you can trim hairs to a length of 1mm, the so-called ‘stubble look’.

Put the precision trimming head on the appliance (see section ‘Attaching and detaching the attachments’ in chapter ‘Preparing for use’).
Switch on the appliance.
Touch the hairs lightly with the precision trimming head and move it against the direction of hair growth.

Note: You can use the precision trimming head with the trimmer teeth pointing towards the skin. You can also use it with the flat part touching the skin and the teeth pointing in the direction in which you move the appliance.

Switch off the appliance.

Trimming with precision trimming head with precision trimming comb

Put the precision trimming head on the appliance (see section
‘Attaching and detaching the attachments’ in chapter ‘Preparing for use’).
Choose the short, medium or long trimming comb, depending on the desired hair length. The indications ‘S’, ‘M’ and ‘L’ are on the combs.
- Short trimming comb (S): 1mm
- Medium trimming comb (M): 3mm
- Long trimming comb (L): 5mm
  Tip: We advise you to start trimming with the long comb.
Slide the trimming comb onto the front of the precision trimming head and push it onto the back until it locks into place (‘click’).
Switch on the appliance.
Move the appliance slowly and with light pressure against the direction of hair growth.

Note: To make trimming easier, stretch the skin with your free hand during trimming.
Note: Make sure that the flat part of the comb always touches the skin to obtain an even result.
Note: Do not press the appliance with the comb onto the skin too hard.
This may cause the appliance to trim the hairs shorter than the length indicated on the comb.
Note: In areas where the hair grows in different directions, move the appliance upwards, downwards and sideways.

Regularly remove cut hairs from the comb. If a lot of hairs have accumulated in the comb, detach the comb from the appliance and blow and/or shake the hairs out of it.
Switch off the appliance.

Shaving with the precision shaving head

Put the precision shaving head on the appliance (see section ‘Attaching and detaching the attachments’ in chapter ‘Preparing for use’).
Place the precision shaving head at a 90° angle onto the skin and move the appliance slowly and smoothly against the direction of hair growth.
Make sure that the whole shaving head is in contact with the skin.
As hairs grow in different directions, move the appliance in different directions (upwards, downwards and sideways).
Switch off the appliance.

Cleaning

Clean the appliance immediately after use and when a lot of hair or dirt
has accumulated on the cutting elements.
Never use compressed air, scouring pads, abrasive cleaning agents or
aggressive liquids such as petrol or acetone to clean the appliance.
Do not tap on the cutting elements.
Do not use any sharp objects to clean the cutting elements.

Switch off the appliance.
Rinse the precision trimming head, the trimming combs and the precision shaving head with lukewarm water.
Note: You can also use the cleaning brush to clean the precision trimming head, the trimming combs and the precision shaving head.
Let all parts dry completely before you use the appliance again.

Ordering accessories

If the trimming combs are damaged or worn, always replace them with original Philips trimming combs. If the cutting element of the precision trimming head or precision shaving head is damaged or worn, replace it.
To buy accessories or spare parts, visit www.shop.philips.com/service or go to your Philips dealer. You can also contact the Philips Consumer Care Centre in your country (see the worldwide guarantee leaflet for contact details).

Environment

Do not throw away the appliance with the normal household waste at the end of its life, but hand it in at an official collection point for recycling.
By doing this, you help to preserve the environment.

Guarantee and support

If you need information or support, please visit the Philips website at www.philips.com/support or read the worldwide guarantee leaflet.
Guarantee restrictions
Cutting units are not covered by the terms of the international guarantee because they are subject to wear.

Troubleshooting

This chapter summarises the most common problems you could encounter with the appliance. If you are unable to solve the problem with the information below, visit www.philips.com/support for a list of frequently asked questions or contact the Consumer Care Centre in your country.

Problem	Cause	Solution
The appliance does not shave long hairs.	The hairs are too long.	Pre-trim

long hairs with the precision trimming head and move the appliance against the direction of hair growth. Make sure that the appliance is fully in contact with the skin.
The appliance does not work as well as it should.| Hairs may be stuck in the precision trimming head or precision shaving head.| Clean the precision trimming head or the precision shaving head (see chapter ‘Cleaning’).
The appliance pulls at the hairs.| You move the appliance too fast.| Do not move the appliance too fast.
The disposable battery is empty| Insert a new battery.
The appliance works, but the result is uneven.| You press the appliance onto the skin too hard.| Do not press the appliance onto the skin too hard, as this may cause the hair length after trimming to be shorter than the indicated hair lengths.
The trimming comb is not in full contact with the skin.| When you use one of the combs, always make sure it is fully in contact with the skin.
Always move the appliance against the direction of hair growth. As not all hairs grow in the same direction, this means that you have to move the appliance up, down and sideways.
The appliance does not work.| The disposable battery is empty or has been inserted incorrectly| Replace the battery or insert it correctly