Shenzhen Chuangyan Electronics CY2019-LY-006 Car Bluetooth Adapter Instruction Manual
- June 5, 2024
- Shenzhen Chuangyan Electronics
Table of Contents
Shenzhen Chuangyan Electronics CY2019-LY-006 Car Bluetooth Adapter
Bluetooth& USB Audio Adapter Cable for Audi (MMI 3G system) and Volkswagen.
Supports external bluetooth audio input and USB power output.Can change
between Phone charging and BT audio.
Product illustration:
Bluetooth ID: Chelink CarElite
- USB Ch arg ing Power output On/Off
- USB Power 5V output(LED indicator in Red)
- LED (BIluetooth/ Charging status indication)
Operating Instructions:
Please be sure that the car has AMI /MDI interface. (The high configuration
model has AMI/ MDI intertace.)
AMI interface usually installed in copilot’s glove box or center armrest box
.
- Open MMI system and switch to “Media”
- Switch the source to Aux mode (external audio in put) Caveat. If the indicator does not light,please confirm the system version.
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for
compliance could Avoid the user’s authority to operate the equipment. This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to
correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
RF Exposure Statement
To maintain compliance with FCC’s RF Exposure guidelines, This equipment
should be installed and operated with minimum distance of 20 cm the radiator
your body. This device and its antenna(s) must not be co-located or operation
in conjunction with any other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>