PHILIPS RS378B GreenSpace Flex LED Downlight Instruction Manual
- October 27, 2023
- Philips
Table of Contents
PHILIPS RS378B GreenSpace Flex LED Downlight
INTRODUCTIONS
- The luminaire shall be installed by a qualified electrician and wired in accordance with the latest IE Electrical regulations or the national requirements.
- Only to be installed outside arms reach as recessed ceiling luminair.
- “The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced”.
ATTENTION
OBSERVE PRECAUTIONS FOR HANDLING ELECTROSTATIC SENSITIVE DEVICES
Modular Dimension
Accessory Dimension
Wear gloves, then connect the module to the cover and turn it clockwise. When you hear a “click”, the module is connected to the cover.
Cut-out and installation height
All configurations require the net installation height for achieving maximum
tilting angle allowed by a given trim, and for thermal management achieving
claimed luminaire life time.
Module, trim and installation heights are given in the table on 1st page.
PSU+PSR Connect Power Supply Cable
Remark: The terminal block of input is press type, insert the cable into terminal block, then pull the cable lightly to make sure the cable is fixed by the terminal block.
Mounting the luminaire
Remark: the recommended dimming controller is Philips DDMC-GRMS, compatible
with the product type RS378B P6 PSR-E M55, RS378B P11 PSR-E M55, RS378B P15
PSR-E M55.
Following installation method is NOT allowed
- Please do not use your bare hand to adjust the core when the light is on
- Turn off the power and wait for 15mins before adjust the core with bare hand
Disconnect before servicing
Luminaire has basic insulation between Low Voltage supply and control conductors.
The control gear and/or the external flexible cable contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person. The light source contained in this luminaire is not replaceable, in case of damage replace the luminaire.
Storage, installation, use, operation and maintenance of the products needs to be performed exactly according the instructions in this manual and/or other instructions as may be provided by us to guarantee sate use of the product over its entire lifetime. Failure to adhere to these instructions will invalidate your entitlement to warranty. Bolts with indication of torque strength on the drawing need to be tightened using a calibrated torque wrench. Pre-assembled bolts need to be retightened again to the required torque specification to assure maximum strength over lifetime.
This product contains a light source of energy efficiency class: see table or label.
© 2021 Signify Holding.
All rights reserved. This document contains information relating to the
product portfolio of Signify which information may be subject to change. No
representation or warranty as to the accuracy or completeness of the
information included herein is given and any liability for any action in
reliance thereon is disclaimed. The information presented in this document is
not intended as any commercial offer and does not form part of any quotation
or contract. Philips and the Philips Shield Emblem are registered trademarks
of Konni Klimke Philips N.V.. All other trademarks are owned by Signify
Holding or their respective owners.
- Signify Holding.
- The Netherlands
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>