Nuvo 65-575R1 LED Backlit Emergency Backup Flush Mount Ceiling Fixture Installation Guide

Nuvo 65-575R1 LED Backlit Emergency Backup Flush Mount Ceiling Fixture

WARNING:

• To reduce the risk of personal injury or property damage from fire, electric shock, falling parts, cuts/abrasions, and other hazards read all warnings and instructions included.
• Before installing, servicing or performing routine maintenance on this equipment, follow these general precautions.
• Commercial installation, service and maintenance of luminaries should be performed by a qualified licensed electrician. If you are unsure about the installation or maintenance of the luminaries, consult a qualified licensed electrician and check your local electrical code.
• Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation.
• Turn off electrical power at fuse or circuit breaker before wiring fixture to the power supply.
• All connections should be capped with UL approved wire connectors.
• Keep away from any corrosive substance.
• Use a dry cloth when cleaning fixture.
• Not suitable for use in wet locations. Suitable for recessed or suspension installation.
  NOTE: Suspension installation kit available separately. (2) 2ft./2 piece or (1) 4ft./3 piece, kits needed for installation.

Specifications

Model #| Size (ft)| Wattage Selectable| Volts| CCT

Selectable

---|---|---|---|---
65-575R1| 2 x 2| 20W/30W/40W| |

3500K/

4000K/

5000K

65-576R1| 2 x 4| 30W/40W/50W| 100-277V
65-577R1| 1 x 4| 20W/30W/40W|
65-585R1| 2 x 2| 20W/30W/40W|
65-586R1| 2 x 4| 30W/40W/50W| 100-347V
65-587R1| 1 x 4| 20W/30W/40W|

Emergency Funtion

INSTALLATION

1. Unscrew driver cover and connect conduit to driver box.

2. Wiring Diagram:
   Do not use the junction to test the line before installation    is completed and AC power supply is provided. Connect wires according to the polar.

3. . Connect coordinating wires. Select desired Kelvin temperature and wattage. Secure driver cover

RECESSED INSTALLATION:

NOTE: Confirm size of fixture to size of ceiling panel. Confirm ceiling can support weight of fixture. The fixture must be fully recessed into the channel. Space for adjustment cannot be more than 1/8″ (33mm) or fixture will fall.

1. Replace existing light fixture with LED Panel.
2. Use protective brackets for safety. See diagrams A, B, C.

SUSPENSION KIT INSTALLATION:

NOTE : Confirm ceiling can support weight of fixture

1. Drill two holes in ceiling and put anchors into hole, then insert the wire rope and screw.
2. Adjust the hanging wire rope so the panel is in a horizontal position

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>