FOSHAN XDJ-021 Remote Control Unit User Manual
- June 14, 2024
- Foshan
Table of Contents
FOSHAN XDJ-021 Remote Control Unit
PRODUCT OVERVIEW
Use Instructions
Remote Battery: Cr205 3V
Frequency : 433.94MHz
How to use the controller ?
- After inserting the DC power adapter, you can use the remote control to control the lamp. Press the “on/off” button to turn off the light.
- There are 7 RGB Dynamic Modes. You can press the ” MODE+/-” Key to choose dynamic colors that you preferred and press the “Speed +/-“key to adjust color change speed.
- There are 7 static colors: White/ Red/Green/Blue/Yellow/Ice blue/ pink light. you can press the “Brightness+/-” key to adjust the brightness.
- You can press the “lock” key to fix the color you like. when you press the “Switch” Dynamic / Static Mode” ket , light will change between dynamic mode and static mode.
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Note: The Grantee is not responsible for any changes or modifications not
expressly approved by the party responsible for compliance. such modifications
could void the user’s authority to operate the equipment.
The device has been evaluated to meet general RF exposure requirement.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>