K F Concept KF34.034 LED Video Light User Manual
- June 14, 2024
- K F CONCEPT
Table of Contents
K F Concept KF34.034 LED Video Light
PRODUCT INFORMATION
Preface
Thank you for choosing the K&F CONCEPT LED video fill light. It is hoped that you can know the use of the product clearly and conveniently through this manual. If you have any questions or suggestions, please contact us at service@kfconcept.com.
Reminder
- When using this product, please use a 5V1A USB charger to charge the device.
- This product adopts a built-in lithium battery. It is forbidden to disassemble, impact, squeeze or put it into fire. In case of a serious bulging of the battery, please cease using the product.
- When using the product, please avoid dripping water or other liquids into the device, to prevent causing a short circuit and device damage.
- Do not use the LED fill light near chemicals, combustible gases or other special substances, which may cause fire or electromagnetic interference. Under the above circumstances, please pay attention to the relevant warning signs;
- Do not disassemble the device by yourself, which may cause damage to the product when touching the internal parts of the product.
Package Checklist
- LED fill light
- 7/4″ screw adapter
- Cold shoe adapter
- Adaptive angle-adjustable clamp
- Filter frame
- Filter
- Charging cable
- Instructions
Product Description
-
Brightness key:
Short press to adjust the brightness of the light (5 levels) -
Color temperature key:
Short press to adjust the light color temperature (white/yellow/Bi-color light) -
On/Off key:
Turn on or off the video light -
Type-C charging port
-
Battery indicator
Product Usage
This product has three installation methods
- Method 1: Use a clamp to fix it on a mobile phone, tablet or laptop and other objects.
1. Insert the part with a snap at the top end of the clamp into the insert hole of the main light.
2. Turn the knob to adjust the light to the angle you need.- Method 2: Use the 7/4 ” screw adapter to fix the light on the light holder.
1. Insert the 7/4″ screw adapter into the insert hole of the light.
2. Align the 7/4″ screw hole with the light holder and rotate to fix it.- Method 3: Use the 7/4″ screw adapter and cold shoe adapter to install the light on the camera.
1. Insert the 7/4″ screw adapter into the insert hole of the light.
2. Screw the nut end of the cold shoe adapter into the screw hole of the 7/4″ screw adapter.
3. Insert the cold shoe adapter base into the cold shoe port of the camera.Remove the clamp or adapter
Press the snap with the tips of your thumb and pull out the clamp or
adapter outward.
Usage of filter
- Align the slot side of t he filter frame with the key surface of the video light and cover it on the video light.
- Insert the filter into the slot of the filter frame.
Remove the filter frame
Pull the two sides of the filter frame with your fingers.
Product Parameter
- Parameter : Description
- Power : 4W
- The number of LED light beads : 84
- Maximum lumen: 250Lux/0.Sm
- Color temperature : 3,000K-70,000K, white, yellow, Bi-color light
- Color rendering index: CRle95
- Brightness level: 5 levels of brightness adjustable
- Battery capacity: 3.7V 2000mAh
- Usage time: Last for 2-2.5 hours in the brightest state
- Input voltage : DC 5V1A
- Operating temperature: -10°C~60°C
- Dimensions of light body : 90’65’75mm
- Light body weight : Approximately 63g
Please Scan For More Information
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>