MONODEAL MD-601 Portable Bluetooth CD Player User Manual
- June 14, 2024
- Monodeal
Table of Contents
Portable CD Player
Model: MD-601 User Manual
IMPORTANT SAFETY INSTRUCTIONS
Please read this manual carefully before using this player and keep it for
later reference.
Warning:
The player
To reduce the risk of fire or avoid the damage to the human body, please
follow the instructions below:
- Never touch the lens of the device. Always keep the disc compartment closed to prevent dust from collecting on the lens.
- If the device is unable to scan discs properly, use a standard commercially available cleaner to clean the laser optics. Other cleaning methods may damage the laser optics.
- Clean the device with a clean, damp leather cloth. Do not use any cleaning agents.
- fthe player fails to work, please contact our after-sales staff i time, professional technical support staff will provide you with detailed answers.
- The player can not be used or stored in moist environment, please keep the player away from any liquid, steam or vapor, such s rain drop, mist etc.
- Please do not place any liquid or metal gadgets onto the player, such as pin or a cup of coffee.
- Please do not expose the player to the sunlight and keep it away from fire heater. The player can not be placed under high temperature environment.
- Al professionals with extensive electronic knowledge and maintenance experience are allowed to disassemble the player for maintenance. The replacement of spare parts must be done in strict accordance with the parameters of the circuit design.
- Please do not stick or hit the player with sharp objects.
- There are light emitting diodes in this player, staring directly with eyes should be avoid to prevent visual impairment from being caused.
- Children under 12 years is not allowed to use the player individually
- When charging, ensure that the Power source and the Charging voltage are DC 5V/1A, Excessive voltage input may cause machine overload damage.
Battery
If the player you purchased contains batteries, please do not disassemble the
player or charge the player with other adapters that do not meet the
electrical parameters of this product to avoid circuit failure.
For your safety, please treat the built-in high-capacity polymer lithium
battery by following the instructions below:
- Please do not remove the battery pack
- Please do not beat or impact this player.
- Please do not make the battery short circuit or pierce it
- Please do not place the player under high temperature which is above140°F (60°C).
- Please do not put the battery in a fire.
- If the battery has been damaged, please ask a professional to replace the battery with same. specification, or contact our after-sales support for help.
Hearing protection
Listen at medium volume:
Please adjust the volume to an appropriate level. If the volume is too high,
it may damage your hearing or even cause a permanent damage. Set the volume to
a low level: Increasing the volume slowly, until a comfortable, clear sound
can be heard.
Listen to the audio within a reasonable time frame:
Long time listening, even at a reasonable volume may cause damage to your
hearing. Please use the product properly and get a rest when necessary.
Environmental protection
To protect the environment and human health, please follow local laws and
regulations on the abandon of the package, electronic product or battery.
Please do not put the product together with household waste.
PACKAGING & PRODUCT
What’s in the box
1*CD player | 1*3.5 to 3.5mm AUX cable |
---|---|
1*USB to Type-C charging cable | 1*User manual |
1*Earphones | 1*Storage bag |
The CD player
Item | Function | Item | Function |
---|---|---|---|
1 | Display screen | 11 | A-B |
2 | MODE | 12 | TF CARD |
3 | EQ | 13 | DC 5V |
4 | Next / Fast forward | 14 | Charging LED |
5 | Previous / Rewind | 15 | Power ON / OFF |
6 | Stop | 16 | Headphone jack 1 |
7 | Play / Pause | 17 | Headphone jack 2 |
8 | Bluetooth | 18 | Volume Konb |
9 | PROG | 19 | OPEN |
10 | DIR | 20 | HOLD ON / OFF |
TROUBLESHOOTING
Problems | Reasons | Solutions |
---|---|---|
Can’t turn on the cd player. | Power switch is not In ON position. | Please |
toggle the power switch to ON position.
Buttons are locked.| Please rtakesuelhe HUD butionattheback °NM FlayerlsinOFF
pasta
CD player is running out of power.| Please charge the cd player.
The player is damaged.| Please contact us or ask a professional for repairs.
Cannot read discs.| The disc is instaled incorrectly.| 1. Make sure the label
side of the disc is facing up.
2. Ensure the disc is inserted fully into the place.
The disc cannot be recognized.| The player is only compatible with CD, CDR,
MP3. HDCD formats.
The disc is dirty or damaged.| 1. Make sure the disc is not heavily scratched
or damaged;
2. Wipe the disc gently from the center radially out to the edge with a clean
& soft cloth;
3. Try another new disc to check if the disc is faulty.
The Bader is dirty.| Wipe the lens gently with a degreasing cotton swab.
NOTE: DO NOT TOUCH THE LENS WITH YOUR HANDS
Can’t charge the CD player.| There is no current at power outlet| Make sure
the power outlet is working.
The plug is not plugged in correctly.| Make sure that the two plugs of the
power cords are connected properly.
The charger is damaged.| Replace the charger with another one matching the
specification (DC 5V/1A).
The player is damaged.| Please contact us or ask a professional for repairs.
NOTE: While charging. please make sure that the Power source and the
Charging voltage are DC 5V/1A. Excessive village input may cause machine
overload damage.
Skip in the middle of the track.| Discs are scratched or not smooth.| Please
use a dry cloth to clean the disc, or try other discs to see it works well.
Noisy and screaming when it plays.| Usage time of the disk may be too long, so
the disk is not smooth.| 1. Make sure the disc is not heavily scratched or
damaged;
2. Wipe the disc gently from the center radically out to the edge with a dean
& soft cloth;
3. Try another new disc to check if the disc is faulty.
If there is a “Jiji” sound inside the earphone, it may be caused by scratching
of the disc.| Please change to another disc, and do not use the old one again
to prevent the player from damage.
USER GUIDE
How to insert a disc
Push the OPEN button o the right to open the door. Insert your index finger
into the center hole of the disc and take the edge of the disc with your
thumb. Keep the side with words upward while inserting the disc into CD
player, press the disc gently to make it steady, and make sure if the disc has
been in place.
Close the disc door gently and completely, otherwise the player will not read
the disc.
(Note: The player s only compatible with CD, CDR, MP3, HDCD
formats.
Insert TF card
After plugging in a TF card into the cd player, Long-press the MODE button to
enter into TF card playback mode.
NOTE: The TF card supports up to 32GB. Over 32GB cannat workwith it
Insert an earphone
Only earphone with 3.5mm plug is compatible with this player. In order to
experience better sound quality, you can use standard earphones of an iPhone
on the player, but some earphones of cellphone may produce noise. If the
earphone cannot be supported by the player, please use standard headphones of
this player.
How to turn on the player
There are two waystotum on the player:
- The power switchis located onthe side. Slide itto the ON position to tum on the player.
- When the power switch is in the ON position, just press the PLAY button once to tum on the player.
NOTE: When a disc is played to the end and there is no activity within 20
seconds, the player il tumed off automatically. Please press the PLAY button
to restart the player How to turn off the player
There are two ways to turn off the player.
- Press the STOP button twice to tum of the player.
- Slide the power switch to the OFF position to turn off the player.
NOTE: Please toggle the power switch to the OFF position if the player is
not used for a long time How to charge for the player
How to Charge: This player only comes with a TYPE C charging cable. Please use
a power adapter to connect with the charging cable to charge the player. Any
5V, 1A USB power adapter will compatible with it.
NOTE: When the battery sign is flashing on the screen, it means that you
need to charge the player.
Charging Time: It will need about 3-4 hours for a full charge. When itis
charging, the LED indicator near the charging port willlight up in RED;
whenit’s fully charged, the indicator will turnto GREEN.
How to connect Bluetooth devices
- Turn on your Bluetooth headphone/speaker and make sure that the Bluetooth is turned on.
- Press the Bluetooth button ( ) of the player. If the Bluetooth is off, you need to press the play button ( ) to turn on the Bluetooth.
- Select “ BT Search ” option, then press the PLAY button, the cd player will start searching nearby Bluetooth devices.
- Press the PLAY button to select the name of your device that needs to connect to.
- After paired successfully, press the BLUETOOTH button to return to the play interface.
Tip: Can not find bluetooth? pls disconnect with other paired device first, such as cellphone.
NOTE:
- When you connect it to your car speaker, if your car bluetooth speaker display PIN Code or password 4 zero (0000) or 6 zero(000000), please change the [PIN Total] on the CD player to 4 or 6 accodingly.
- You can press and hold ( ****) button for 2-3 seconds to make bluetooth ON/OFF easily.
OTHER FEATURES
Key lock
After playback mode and sound effects have been setup, you can toggle the
power switch to the HOLD position in order to prevent the environment, for
example naughty children or crowded occasions from affecting the setting of
player. Connect to the car radio/speaker
You can use this cd player in the car via the car’s radio/speaker, using the
included 3.5mm male-to-male cable to connect your car’s 3.5mm AUX port with cd
player’s headphones jack.
NOTE: The player ONLY works with the 3.5mm AUX port. (A USB port is NOT
supportable).
Connect to other 3.5mm audio devices
You can use this cd player to connect any other audio devices that also have a
3.5mm audio jack, such as speakers, home theater, headphones amplifiers, etc.
PLAY
How to setup the circle mode
Each time the MODE button is pressed, the order of the tracks played will be
as follows:Repeat 1( 1).
Repeat all ( ALL), random play (RAND) preview play (INTRO) (only 10 second per
track will be played in this mode). How to program the play
Press the PROG button to enter the programming mode when the play stops, press
the PREVIOUS or NEXT button to select the track you want to program, press
PROG again (o confirm the programming.
Up 0 30 tracks can be programmed in this mode. After that, press the PLAY
button to enter the, programming play mode. Press the STOP button directl to
enter the stop mode to cancel o reprogram. How to Set A-B Repetition
If you just want to repeat the specific part of atrack, when the player is
played that part, please press the A-B button one time, the display show A
ON”, then when & plays to the end of that part, press the A-B button once
again, the display show “Ab ON” After that,the player will only repeat that
specific part.
NOTE: ffyou want to stop repeafing that part,just press the A-B button
once again, the display show “Ab OFF”, it wil play in an order
How to setup sound
How to adjust volume
The volume knob is located on the side of the player. Rotate it to the left or
right to decrease or increase the volume. Please listen to music at an
appropriate volume to protect your ears. How to setup EQ effect
Press the EQ buton to changes the diferent sound effects. There are a total
of 5 sound effects: BBS, POP, JAZZ, ROCK, and CLASSIC.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>