POTTER amseco SSX-82 Durable Siren Instruction Manual
- June 9, 2024
- POTTER
Table of Contents
OUTDOOR/INDOOR DUAL-TONE
DURABLE SIREN SSX-82
DURABLE SIREN/STROBE COMBINATION
INSTRUCTION
GENERAL DESCRIPTION
SSX-82 is a durable self-contained outdoor and indoor siren that eliminates
the need for an additional siren box and tamper switch mounting which is
generally used on a conventional installation. The SSX-82 durable siren
consist of a strong and rust free polycarbonate plastic cover housing, 125dB @
a foot output siren driver with two siren filed selectable tones and a N/C
plunger type tamper switch for supervison.
The durable siren DOES NOT require additional modules, metal boxes, tamper
switches, or special tools to install and operate. The SSX-82 comes completely
assembled and ready for installation. Also available the SSX-82S Siren /
Colored strobe Combination. (Amber, Blue, Clear or Red lens to choose from.)
INSTALLATION
- Remove the Plastic cover housing by loosening the screws.
- Mount the aluminum bottom plate direct to the wall or mount BBK-1 outdoor box.
* When wiring from the side, use the knock-out holes provided on the top and bottom of the plastic cover housing. - Plastic cover housing can be hooked-up as per drawing.
SPECIFICATION
| SSX-82| SSX-82S
---|---|---
Rated voltage| 12VDC
Rated current| 1.20A at 12VDC (typical)| 1.31A at 12VDC (typical)
Sound output| 125dB @ 1 foot
Operating voltage| 4.8-14.4VDC| 9.6∼14.4VDC
Flashing rate| –| 20∼100 flashes/min.
Tamper switch contact capacity| 0.3A Max. at 12VDC
Operating temperature range| —4°F’ +149°F / —20°C — +65°C
Lens color| –| Amber, Blue, Clear, Red
NOTE
* Siren sound quality varies with the power supply. If the power source has
a high rippled, siren driver does not creates the best sound. Best siren sound
should be made with a lower rippled power supply.
-
Please do not touch electronic components when you install the siren, it may cause damage.
- Wiring should be made as per drawing, and AWG #12 to #20 should be used. Siren/Strobe combination model installation should be same method of the above. Self-rising clamps used for the terminal screws do not require spade terminal.
Wiring method of the SSX-82S Connect the Red lead wire from the strobe light to the (+) tab on the inner cover, the Black lead goes to ( — ) terminal as per drawing. - After completion of wiring, mount the plastic cover back and secure with screws. The tamper switch must be pushed by the cover housing.
- Wiring should be made as per drawing, and AWG #12 to #20 should be used. Siren/Strobe combination model installation should be same method of the above. Self-rising clamps used for the terminal screws do not require spade terminal.
External dimensions : inch (mm)
Potter Electric Signal Company, LLC
1609 Park 370 Place, Hazelwood, MO 63042
Phone:800-325-3936/Canada
888-882-1833
www.pottersignal.com
SSX-82S
INST. SHT. No. SSX82-H1008 S100713
Documents / Resources
|
POTTER amseco SSX-82 Durable
Siren
[pdf] Instruction Manual
SSX-82, SSX-82S, amseco SSX-82 Durable Siren, amseco SSX-82, Durable Siren,
Siren
---|---