VICTROLA 50s Retro Bluetooth Record Player and Multimedia Center with Built In Speakers User Guide
- June 14, 2024
- Victrola
Table of Contents
50s Retro Bluetooth Record
Player and Multimedia Center
with Built In Speakers
User Guide
FAQ
How long do needles typicallylast?| The stylus should last about 50 hours
under normal use.
---|---
What is the best way to store the unit?| Keep record players in clean, dry
locations. Keep all accessories with your unit such as the manual, power
adapters, needles, etc. Do not stock anything on top of your vinyl OR record
players.
How should I clean my unit?| Remove dust with a clean lint-free cloth
semiregularly. In order to clean the unit, we recommend a slightly
moistened towel to remove build up as well as a dry cloth to remove any
extra moisture.
How are record players packaged when shipped?| Packages are double boxed and
sealed with packing tape to assure that your item will not move around or
become damaged during the shipping process. Please be aware to unscrew the
safety screw that holds down the platter so it
will not be damaged in shipping.
Speaker Connection|
Can I wirelessley stream music to my record player from a Bluetoothdevice?|
Yes, you can pair a Bluetooth enabled device to play through the internal
speakers.
How do I connect a wired speaker to my device?| If applicable with your model,
a wired speaker can be connected via RCA cable. For Amplifier device with this
input,
insert the white and red plugs on the RCA cable into the unit. Insert the
opposite end into the amplifier device. Be sure
to connect the white plug to white jack and the red plug to the red jack or
this connection will not work.
Set up|
How do I play 45s on my record player?| First, take the 45 adaptor and place
it over the center of the turntable. Then, change the speed to 45 on the speed
selector located to the right of the tone arm. You can now play your favorite
45’s!
How do I set up my record player?| Start by unboxing your record player and
making sure you have received all the correct pieces. Make sure to find a
straight, level area to place your record player as any slanted surface can
cause an issue with the player skipping. Plug in the power cord to the
appropriate power supply and into the back of the player. If your records are
not playing properly or the turntable is not spinning, then please try
adjusting the screw on the back of the turntable by turning it a quarter of a
turn each time and then try playing a record.
How do I install a replacement needle?| Removing the Stylus from the Cartridge
1. Set a screwdriver at the tip of the stylus and push down gently.
WARNING: When applying force to the stylus, too much may damage the
stylus.
2. Pull the stylus out in a slightly downward direction.
Installing the Stylus
1. Hold the tip of the stylus and insert the other edge in an upwards
direction.
2. Push the stylus up until it locks it at the tip.
TROUBLESHOOTING
Why is my turntable humming?| Please make sure your power cord is fully
plugged into the unit and the outlet. Then, be sure the unit it away from
other electronic devices that may cause interference.
---|---
Why is the platter wobbly?| The turntable platter is built on top of springs
and it is not designed to fit firmly in place on top of the wood. This design
allows the record player to turn smoothly without grazing against the wood.
How do I reset/reboot my unit?| In order to reboot just unplug the unit from
the wall outlet and then let the unit rest for about 6-8 hours.
My drive belt or motor stopped working| Please contact
support@victrola.com for assistance.
My record player is playing too fast or too slow| There is a screw at the back
of the turntable that balances the turntable and the tonearm weight if the
records do not play properly or if the turntable does not spin. This is the
only adjustment available on the unit. If your records are not playing
properly or the
turntable is not spinning then please try adjusting that screw by turning it a
quarter of a turn each time and then try playing a
record. If it does not sound properly then keep the arm back in the rest
position and then again adjust the screw by a quarter of a turn. Then try
playing the record again. Do this process till you get your records playing
perfectly.
I lost my manual| Please refer to our manual repository located on our site:
https://victrola.com/pages/owners-manuals
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>