PowerLocus P3 Bluetooth Headphones Over Ear User Manual
- June 14, 2024
- PowerLocus
Table of Contents
PowerLocus
P3
Email Support: info@powerlocus.com
PACKING LIST
Headphone x1
Type -C Audio input cable x1
Type -C charging line x1
PRODUCT OVERVIEW
- Power : Power on / Power off
- Short press: Volume Up / Long press: Next song
- Pause /Play/ Answer/hang up the phone Bluetooth connected: Double-click to call a recent call
- Short press: Volume Down / Long press: last song
- Type C Audio port / Charging port
- Microphone
- Indicator light
BT Version: V5.3
Speaker Size: 40mm
Speaker impedance: 32Ω±15%
Speaker sensitivity: 110±3dB
Frequency Response: 20-20KHz
Battery talk/music time: about 50H
Battery capacity: 400mAh
Battery charging time: about 2.5H
Charging interface: Type-c
Audio interface: Type-c
OPERATING INSTRUCTION
3.1 PAIRING
Long press(1) On/Off button to turn on the headset.
Open the smart device Bluetooth menu and then Select the Bluetooth name
PowerLocus P3
3.2 WHEN MUSIC IS PLAYING
Click: Volume Plus
Long press: Next song
Click: Volume down
Long press : Last song
Click: Play/Pause
3.3 WHEN THE PHONE IS ON HANDS-FREE
Short press: Answer/hang up the phone
Double press : Call back
Long press for 1.5 seconds : Reject the call
3.4 HOW TO RESET THE HEADPHONES?
Hold both Buttons for 4-7 seconds in order to reset the bluetooth and enter
pairing regime again.
LED LIGHT INTRODUCTION
Turning ON:The white light appears and Flashes for 2 seconds
Turning OFF: The green light flashes 2 times and then goes off
BLUETOOTH CONNECTED: Lights GO OFF and White LED flashes every 20 seconds
PAIRING REGIME: Green / White lights is flashing alternately
Disconnected state: Green / White lights is flashing alternately
Headphones Charging Status: Constant Green Light is ON
Fully charged headphones: Green light GOES OFF
Low battery indication: Green light flashing
HOW TO CHARGE THE HEADPHONES?
Please charge the headphone with the USB cable provided before your first use
Step 1: Connect one side of the USB cable into the USB-C port on the
headphone
Step 2 : Directly connect the other side into a USB Wall outltet / Laptop
or PC usb port in order to charge the headphone HOW TO USE THE WIRED MODE?
Plug the USB-C to 3.5mm Aux cable into the headphone and side of the cable –
3.5mm Aux to the Aux port of the device you intend to play music from.
The headphone turns into a wired headphone and the battery will not work until
you remove the audio cable. CE
Hereby GL Grup-2015 LTD declares that wireless headphone PowerLocus P3 is in
compliance with essential requirements and other relevant conditions of
Directive 2014/53/EU.
The full text of the EU declaration conformity is available at the following
internet address: (powerlocus.com/doc) Frequency:
2402-2480 MHz
Max radio frequency power: 100 mW (EIRP)
GL GRUP-2015 LTD.
36 VASIL LEVSKI STREET, 5370 DRYANOVO,
BULGARIA
Warning:
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept anyinterference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television
reception which can be determined by turning the equipment off andon, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
NOTE: This device and its antenna(s) must not be co-located or operation
in conjunction with any other antenna or transmitter.
The device has been evaluated to meet general RF exposure requirement.
ISED Canada Statement:
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation,
Science and Economic Development Canada ‘s licence exempt RSS(s). Operation is
subject to the following two conditions:
this device may not cause interference and this device must accept any
interference, including interference that may cause undesired operation of the
device.
Radiation Exposure: This equipment complies with Canada radiation
Exposure limits set forth for an uncontrolled environment to maintain
compliance with IC’s RF
Exposure guidelines. This equipment should be installed and operated with
minimum distance of 0mm the radiator your body. This device and its antenna(s)
must not be co-located or operation in conjunction with any other antenna or
transmitter.
**** This symbol on a product means that the product is covered by European
Directive 2012/19/EU. Electrical products should not be disposed of with
household waste. Please recycle them at the collect points provided for this
purpose. Contact the local authorities or your dealer for recycling advice.
Proper disposal of old appliances helps preserve the environment and health
Safety Instructions
- Please charge the headphones before first time using.
- Please charge at least once every 3 months to keep battery in good condition.
- To protect your hearing, please do not use the headphones long time with too high volume.
- Do NOT expose the headphone to hot temperature
- Protect from shocks and drops
- Do NOT try to open the product
- Do NOT expose to moisture, rain and liquids