VIVO DESK-V000VC Corner Height Adjustable Cubicle Stand Up Desk Instruction Manual
- June 14, 2024
- Vivo
Table of Contents
VIVO DESK-V000VC Corner Height Adjustable Cubicle Stand Up Desk
Assembly Video & Product Info
https://vivo-us.com/products/desk-v000vc
CAUTION!
If you do not understand these directions, or if you have any doubts about
the safety of the installation, please contact our product support team at
309-278-5303 or help@vivo-us.com for
further assistance. Check carefully to make sure there are no missing or
defective parts. Improper installation may cause damage or serious injury. Do
not use this product for any purpose that is not explicitly specified in this
manual. Do not exceed weight capacity. We cannot be liable for damage or
injury caused by improper mounting, incorrect assembly or inappropriate use.
-
WARNING: CHOKING HAZARD
SMALL PARTS – NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED. -
DO NOT EXCEED WEIGHT CAPACITY
FAILURE TO DO SO MAY RESULT IN SERIOUS INJURY. -
WARNING: PINCH POINT
DO NOT PLACE HANDS ON OR NEAR SUPPORT BARS. MOVING PARTS CAN CRUSH AND CUT. PINCH POINTS ARE CREATED DURING LIFTING AND LOWERING THE WORKSURFACE. FAILURE TO FOLLOW THESE
INSTRUCTIONS MAY RESULT IN SERIOUS PERSONAL INJURY.
We’re Here for You
Open Monday – Friday 7:00am – 7:00pm CST, our dedicated support team can offer
immediate assistance with rapid response times. If any parts are received
damaged or defective, please contact us. We are happy to replace parts to
ensure you have a fully functioning product.
Package Contents
ASSEMBLY STEPS
STEP 1 Carefully remove Desktop (A) from the packaging.
STEP 2 Flip Desktop (A) upside down, then attach the Extended Feet (B) to frame using M5x10mm Screws (S-A).
STEP 3 Press the handles on each side and lift Desktop (A).
STEP 4 Mount Brackets (C) to Keyboard Tray (D) using M5x10mm Screws (S-A).
STEP 5 Hang assembled keyboard tray onto pre-installed knobs, and tighten
knobs to secure.
NOTE: Make sure the keyboard brackets are curving towards the user, not
towards the inside of the desk.
STEP 6 Attach Cable Clip (D) to desk to manage keyboard and mouse cables. Manage cables using Zipties (E).
ASSEMBLY COMPLETE
Assembly is complete and your desk riser is now ready for use.
Press both side levers to raise or lower your desk riser.
When lowering without any weight on the desktop, lightly press down on riser
as you lower it to allow for a smoother lowering process. If it feels
difficult to lower after placing laptop and other intended setup items, apply
light pressure to lower smoothly or add additional weight.
Please note the 33lb weight capacity when adding weight.
TENSION ADJUSTMENT
If your desk riser lifts up or down too easily, or is too difficult, the gas
spring cable can be adjusted to your desired tension.
This adjustment is located in two places:
1. Levers: Behind both levers, under desktop.
2. Gas Spring Tip: At the tip of the Gas Spring
Notes:
- The images will focus on the adjusting near the Levers, but the process are the same, and the steps can be applied to either location.
- Any adjustments made need to be applied to both side of the riser.
- Images shown here show the maximum and minimum tensions. In most cases, your ideal tension will be somwhere in the middle.
Begin by loosening the Inner (1) and Outer (2) Nuts using an adjustable wrench. Loosen Nuts until they are both on the opposite ends of the Gas Spring Cable.
Option A:
Desk Is Difficult to Raise/Lower | Increase Tension
If the desk feels difficult to raise and lower, then you will need to
increase the Gas Spring Cable tension. Gently pull the cable away from the
Lever until the Inner Nut (2) is firmly pressed against the middle divider.
Tighten Outer Nut (1) until it firmly holds the cable in its position, as shown below.
Option B:
Desk Raises/Lowers Too Easily | Decrease Tension
If the desk is raising or lowering without the handle being pressed, then
the tension needs to be loosened. Gently push the cable towards the Lever the
Outer Nut (1) is firmly pressed against the middle divider.
Tighten Inner Nut (2) until it firmly holds the cable in its position, as shown below.
CAUTION
References
- Register a .US.COM domain today!
- VIVO - Desks, Monitor Mounting, and More Home & Office Solutions – VIVO - desk solutions, screen mounting, and more
- 44" Corner Standing Desk Converter – VIVO - desk solutions, screen mounting, and more
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>