ALLMATIC KAIROS S Wind Sensors Cable Connection Instruction Manual
- June 14, 2024
- ALLMATIC
Table of Contents
ALLMATIC KAIROS S Wind Sensors Cable Connection
REMARKS
Please read this instruction manual very carefully before installing and programming your control unit.
- The device must not be used by people (children included), whose physical, sensory and mental capacities are reduced, or without experience or knowledge, unless they could benefit through the intermediation of a person responsible for their safety, of a surveillance or of instructions related to the use of the device.
- Children must be kept under surveillance to make sure that they do not play with the device.
- If the power supply’s cable is damaged, it must be substituted by the manufacturer or by his assistance service or in any case by a person with similar status in order to prevent any risk.
- This instruction manual is only for qualified technicians, who specialize in installations and automations.
- The contents of this instruction manual do not concern the end user.
- Every programming and/or every maintenance service should be done only by qualified technicians.
- The installer must provide for a device (es. magnetotermical switch) ensuring the omnipolar sectioning of the equipment from the power supply.
DESCRIPTION
The device can work only combined with an Allmatic control unit.
This device must be installed where it can detect the presence of wind,
therefore not in places shielded by walls or protrusions. For the connections
it is not necessary to observe any polarity; in any case it is advisable to
follow the technical instructions of the control unit.
ASSEMBLING AND CONNECTIONS
The assembling happens in stages :
- Fix on the wall the plate using the drilling plan at at least 2 meters from the earth
- Apply the seal, by passing the cable through the hole
- Connect the cable to the terminals of the sensor
- Screw the sensor to the wall plate
- Cover with the shells
- Adjust the angle so that the blades rotate horizontally, screw the socket head screw and close with the cap provided
Fixing examples :
WEEE – INFORMATION FOR USERS
If the crossed-out bin symbol appears on the equipment or packaging, this means the product must not be included with other general waste at the end of its working life. The user must take the worn product to a sorted waste center, or return it to the retailer when purchasing a new one. Products for disposal can be consigned free of charge (without any new purchase obligation) to retailers with a sales area of at least 400 m2 , if they measure less than 25 cm. An efficient sorted waste collection for the environmentally friendly disposal of the used device, or its subsequent recycling, helps avoid the potential negative effects on the environment and people’s health, and encourages the re-use and/or recycling of the construction materials.
GUARANTEE
In compliance with legislation, the manufacturer’s guarantee is valid from the
date stamped on the product and is restricted to the repair or free
replacement of the parts accepted by the manufacturer as being defective due
to poor quality materials or manufacturing defects. The guarantee does not
cover damage or defects caused by external agents, faulty maintenance,
overloading, natural wear and tear, choice of incorrect product, assembly
errors, or any other cause not imputable to the manufacturer. Products that
have been misused will not be guaranteed or repaired.
Printed specifications are only indicative. The manufacturer does not accept
any responsibility for range reductions or malfunctions caused by
environmental interference. The manufacturer’s responsibility for damage
caused to persons resulting from accidents of any nature caused by our
defective products, are only those responsibilities that come under Italian
law.
DRILLING PLAN
Cut out the shape below for drilling the holes in the surface where the sensor
will be placed.
Customer Support
ALLMATIC S.r.l
32026 Borgo Valbelluna – Belluno – Italy
Via dell-Artigiano, n°1 – Z.A.
Tel. 0437 751175 – 751163 r.a. Fax 0437 751065
http://www.allmatic.com – E-mail :
info@allmatic.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>