TYGER TG-HC2J001K Towing Combo Hitch Kit Installation Guide

June 14, 2024
TYGER

TYGER TG-HC2J001K Towing Combo Hitch Kit Installation Guide

TYGER TG-HC2J001K Towing Combo Hitch Kit.jpg

TG-HC2J001K

BEFORE INSTALLATION

READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. REMOVE CONTENTS FROM BOX AND VERIFY ALL PARTS ARE PRESENT. FAILURE TO IDENTIFY DAMAGE BEFORE INSTALLATION COULD LEAD TO A REJECTION OF ANY CLAIM. IF MISSING PARTS OR ANY DAMAGE FOUND, PLEASE TAKE A PICTURE FOR THE CLAIM PURPOSE. TO FILE YOUR CLAIM, PLEASE VISIT: WWW.TYGERAUTO.COM/CONTACT

TORQUE VALUES

FIG 1 TORQUE VALUES.JPG

Parts List

FOR 2007-UP Wrangler JK 2DR & 4DR

FIG 2 Parts List.JPG

FIG 3.JPG

Customer Support: www.tygerauto.com/contact

PROCEDURE:

REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.

STEP 1

Slide the receiver over the rear crossmember, taking care to align the 4 holes in the receiver with the 4 holes in the cross member. Once in place, insert left or right most bolt with flat washer into the back side of the hitch and through the cross member. Place the nylock nut and flat washer on to the bolt. Secure but DO NOT tighten (Fig 1).

FIG 4 PROCEDURE.JPG

STEP 2

Once all 4 bolts and nylock nuts have been started, tighten them.
The nuts will need to be held in place with an open end wrench.
Torque all 1/2″ bolts to 110 lb-f. (For Rubicon X & 10th Anniversary models, use factory bolts instead of supplied bolts (Fig 2).

FIG 5 PROCEDURE.JPG

STEP 3

Insert the trailer wiring, if equipped, into the trailer wiring mounting tab on the receiver as shown. Installation is now complete.

FIG 6 PROCEDURE.JPG

STEP 4

Place vehicle in gear and arm the emergency break. Remove rear driver’s side tail light (Fig 4).

FIG 7 PROCEDURE.JPG

STEP 5

Disconnect taillight connector as shown (Fig 5).

FIG 8 PROCEDURE.JPG

STEP 6

Connect new loom to male and female connectors (Fig 6).

FIG 9.JPG

STEP 7

Fish trailer connecter down through taillight opening and past foam isolator panel (Fig 7).

FIG 10.JPG

STEP 8

After pulling loom through foam isolator drop connector over frame and insert into the tow hitch plug notch (Fig 8).

FIG 11.JPG

STEP 9

Locate small 8mm holes drilled along frame and press in retainer clips. Test all light functions before towing (Fig 9).

FIG 12.JPG

Customer Support: www.tygerauto.com/contact

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals