Kanto CM600SG Weatherproof Full Motion ceiling Mount for Outdoor TVs User Manual

: June 15, 2024
: Kanto

Kanto CM600SG Weatherproof Full Motion ceiling Mount for Outdoor TVs User Manual

Thank you for choosing Kanto

Read these instructions fully before assembly and installation. If you do not understand these directions, or have any doubts about the safety of the installation, please consult a qualified installation contractor. Make sure there are no defective or missing parts. Do not use defective parts. Kanto cannot be liable for property damage or injury caused by incorrect mounting, incorrect assembly, lifting or incorrect use of this product. If there is hardware missing, or if you are uncertain whether a part is defective, please contact Kanto directly using one of the methods below.

CAUTION
The maximum loading weight is 88 lb (40 kg). This mount is intended for use only with the maximum weights indicated Use with products heavier than the maximum weights indicated may result in instability causing possible injury. The wall you plan to affix the Kanto mount to must be able to support more than 5 times the weight of the television and the mount combined. Do not use this product for any purpose other than to mount a VESA compliant TV on a vertical surface as outlined in this manual. Improper installation may cause damage to your TV or serious injury. This product should not be mounted on steel stud walls or cinder block walls. Consult a qualified installation contractor if you are unsure about the type of wall you may have.

US & Canada: 1-888-848-2643 UK: +44 800086999

support@kantoliving.com

See installation video online at:
www.kantomounts.com/resources

Supplied Parts and Hardware

Required Tools

Wood stud wall

Concrete wall

Project Overview

Select TV Screws and Spacers
Select Spacers for Irregular TVs
Attach TV Brackets
Mount Wall Plate Assembly
Attach Wall Plate Covers
Hang and Secure TV
Level TV
Finalize Adjustments
Manage Cables

IMPORTANT!: Please read this entire document before attempting assembly.

If you have any problems or difficulties while following these instructions, please contact Kanto directly:
Email:support@kantoliving.com
Toll Free: US & Canada: 1-888-848-2643 | UK: +44 800086999

Select TV Screws and Spacers

A–I Select Screws

The back of your TV has 4 screw holes in a square or rectangular pattern. This is where the mount will attach to your TV. Kanto provides several sizes and lengths of screws. This guide will help you select the right screws for your TV. You will only use 4 of the provided screws to attach your TV – the rest are not needed.

Select Spacers for Irregular TVs

Spacers can be used to provide clearance around protrusions on the back of your TV, or to accommodate a curved TV. You may need to use longer screws.

Attach TV Brackets

WARNING

Do not lay the TV face down on its front. Use a wall or TV stand

VESA
100 x 100100 x 150 100 x 200 150 x 100 150 x 150 200 x 100 200 x 150 200 x 200 3a.

VESA
200 x 250 200 x 300 200 x 400 300 x 200300 x 300 400 x 200 400 x 300 400 x 400 3b. Pg.8
Assembly Instruction

Assembly Instruction

Mount Wall Plate Assembly (Wood Stud Wall)

Assembly Instruction

Mount height depends on TV size, viewing position, and personal preference.
Assembly Instruction

WARNING
Do not use concrete anchors in drywall or wood stud walls.

CAUTION

Make sure the supporting surface will support the load limits outlined in the caution on page two. Tighten lag bolts (O) until the wall plate is snug against the wall. Do not over tighten the lag bolts (O). Each lag bolt must be located in the middle of a wood stud.

4b. Mount Wall Plate Assembly (Concrete Wall)

Mount height depends on TV size, viewing position, and personal preference.

WARNING
Do not use concrete anchors in drywall or wood stud walls.

Assembly Instruction

CAUTION

Make sure the concrete or brick wall is at least 4” thick. Make sure the anchor is seated completely flush with the concrete surface even if there is another layer of material, such as drywall. If drywall is over 5/8” thick, custom lag bolts must be used. Concrete must be a minimum of 2000 psi in density.

Attach Wall Plate Covers

Assembly Instruction

Hang and Secure TV

Assembly Instruction

cont’d

Assembly Instruction

Level TV

Assembly Instruction

Finalize Adjustments

Assembly Instruction

Manage Cables

Assembly Instruction

Limited Warranty to Original Purchaser

Kanto Living Inc. (Kanto) warrants the equipment it manufactures to be free from defects in material and workmanship for the limited warranty period of 5 years.

If equipment fails because of such defects and Kanto is notified within 5 years from the date of shipment with proof of original invoice from an authorized reseller, Kanto will, at its option, provide replacement parts or replace the equipment, provided that the equipment has not been subjected to mechanical, electrical, or other abuse or modifications. Any replacement parts or replacement units are warranted for 90 days from the day of reshipment to the original purchaser.

Customers will be responsible for obtaining a Return Authorization Number and paying shipping costs to return product to a Kanto location or authorized depot. If the equipment is covered under the warranty provisions above, Kanto will replace parts or provide a replacement unit, and be responsible for shipping costs to the customer. Please keep the original packaging to prevent damage to the product during shipping. Insuring your shipment is also recommended.

The information in the manual has been carefully checked and is believed to be accurate. However, Kanto assumes no responsibility for any inaccuracies that may be contained in the manual. In no event will Kanto be liable for direct, indirect, special, incidental, or consequential damages resulting from any defect, even if advised of the possibility of such damages. This warranty is in lieu of all other warranties expressed or implied, including without limitation, any implied warranty or merchantability or fitness for any particular purpose, all of which are expressly disclaimed.

PS100/PS200

Before drilling tape over each hole to minimize the amount of dust.
Assembly Instruction

THANK YOU FOR CHOOSING KANTO

As a company of passionate AV enthusiasts, we take pride in designing, manufacturing and supporting products that will enhance your digital lifestyle.
If there’s anything we can do to improve your experience with our products, don’t hesitate to email us at support@kantoliving.com or call us toll-free at 1-888-848-2643 during westcoast business hours.
We’d love to hear from you!

PLEASE REVIEW US!

If you’re satisfied with your purchase, we’d truly appreciate it if you could leave a review with the retaller you purchased your product from. Endorsements from customers like you help us immensely, and provide others with the infor- mation they need to make informed purchase decisions.

FOLLOW US!