GENERATION LIGHTING 990TRAVDRCT Traverse Direct Instruction Manual
- June 13, 2024
- GENERATION LIGHTING
Table of Contents
GENERATION LIGHTING 990TRAVDRCT Traverse Direct
Product Information
The Traverse Direct (model number 990TRAVDRCT) is a ceiling fixture designed for installation in damp locations. It is intended to be installed using NEC compliant junction boxes. The product is designed to provide lighting and comes with a diffuser.
- Manufacturer: Generation Lighting
- Address: 7400 Linder Ave., Skokie, IL 60077
- Contact: T 847.410.4400 | F 847.410.4500
- Website: www.generationlighting.com
Product Usage Instructions
- Ensure you have a NEC compliant junction box installed in the desired location.
- Before installation, read and familiarize yourself with the applicable installation code and any hazards involved.
- Save the provided instructions for future reference.
- Position the fixture over the junction box, aligning the keyhole slot on the fixture with the junction box screw.
- Insert the junction box screw into the keyhole slot and rotate it clockwise to secure the fixture in place.
- If needed, tighten the junction box screws until snug.
- Screw the diffuser clockwise onto the fixture to reinstall it.
Note: These instructions provide a general guide for installation. Always refer to the specific installation code and guidelines for your location and consult a professional if you are unsure about any step of the installation process.
GENERAL PRODUCT INFORMATION
- These fixtures are intended to be installed utilizing NEC compliant junction boxes.
- This product is safety listed for damp locations.
- This instruction shows a typical installation.
CAUTION – RISK OF FIRE
- This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
- Use minimum 90°c supply conductors.
SAVE THESE INSTRUCTIONS
Install the Fixture
- Remove the diffuser from the fixture by twisting it counterclockwise.
- Install junction box screws into the junction box, leaving enough length to install the fixture using the keyhole slots.
- Connect the fixture to a suitable ground in accordance to local electrical codes.
- Connect the white fixture wire to the neutral power line wire with a wire nut.
- Connect the black fixture wire to the hot power line wire with a wire nut.
- Properly place the wire nuts and wires into the junction box, align the keyhole slots on the fixture with the junction box screws, push the fixture flush against the ceiling, and rotate it clockwise to lock in place. If necessary, screw the junction box screws until snug.
- Reinstall the diffuser by screwing it clockwise onto the fixture.
CONTACT
- GENERATION LIGHTING
- 7400 Linder Ave., Skokie, IL 60077
- Т 847.410.4400 | F 847.410.4500
- www.generationlighting.com.
©2022 Visual Comfort & Co., L.L.C. All rights reserved. The Visual Comfort & Co. logo is a registered trademark of Visual Comfort & Co. Visual Comfort & Co. reserves the right to change specifications for product improvements without notification.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>