RUGGED RIDGE 11540.16 XHD Modular Overrider Hoop Installation Guide
- June 13, 2024
- RUGGED RIDGE
Table of Contents
11540.16 XHD Modular Overrider Hoop
Installation Guide
11540.16 XHD Modular Overrider Hoop
Components
-
Stainless Hoop………………………..(1)
-
Stainless 8mm Washer……………(8)
-
Stainless 8mm Bolt………………….(8)
-
Center Section of Modular HD Bumper should already be installed on vehicle. If hoop is replacing a different style of hoop, remove it such that you are left with empty top holes.
-
Position Hoop over the Center Section, aligning the holes in the Hoop with the holes in the top of the Center Section.
Note: The Hoop can be installed leaning back or leaning forward, depending on the desired look. -
Start all bolts, but do not tighten them.
-
Once all 8 bolts have been started, tighten them. Installation is now complete!
Note: Hoop is not to be used for vehicle recovery. Only the D-Rings on the front of the bumper are to be used. Hoop is not to be used for towing or vehicle recovery.
Congratulations on the purchase and installation of a quality Rugged Ridge product! Ask your retailer about the following additional accessories to the JK Modular HD Bumper:
OMIX-ADA® TECHNICAL SUPPORT
PHONE: M-F 8am – 5pm EST 1-800-449-6649
EMAIL: techsupport@omix-ada.com
FOR WARRANTY INFORMATION VISIT: www.Omix-Ada.com
Copyright © 2022 Omix-Ada ® , Inc.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>